TRAC T10116 User manual

Anchor up Anchor down
Press ON : The remote control is turn on
Press triangle on top-left : Anchor up
Press traingle on top-right : Anchor down
Press OFF : The remote control is off
Wireless Remote
Model : T10116
FCC ID: ZWNT10116

FCC 6WDWHPHQW
FederalCommunication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
-Reorient or relocate the receiving antenna.
-Increasethe separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consultthe dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.