Operating Instructions
HC 7360H
Touch Sensor Six Motor
Massage with Heat
Massage : Touch POWER to back light the wand.
Touch POWER , WAVE, PULSE or STEADY to
turn Massage ON. Once activated MASSAGE has a 30
minute timer. To turn off, touch Power.
Zone: Touch Zone 1, 2 or 3 to choose the location of
the massage to control.
Wave / Steady/ Pulse : Press Wave, Steady, or
Pulse keys to choose Massage type
Intensity +/-: Touch + or –keys to increase
or decrease Massage intensity
Speed +/-: Touch + or -keys to increase or
decrease the Massage speed (PULSE and
WAVE modes only)
Heat: Touch HEAT key to activate the High and again
for LOW and a third time to turn off. Once activated
there is a 30 minute timer.
Note: Use only the power supply furnished with the
unit.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce risk of injury to persons:
READ INSTRUCTIONS BEFORE OPERATING.
INJURY MAY RESULT FROM IMPROPER USE.
NEVER REMOVE COVERS.
•This appliance should never be left unattended when in operation.
•Unplug appliance from outlet before relocating or troubleshooting.
•Do not connect an extension cord to this unit.
•Close supervision is necessary when this appliance is used by, on, or near
children, invalids, or disabled persons.
•Use this appliance only for its intended use as described in the operating
instructions.
•Do not use attachments not recommended by the manufacturer.
•Keep all cords away from heated surfaces and pinch points.
•Do not use outdoors. INDOOR USE ONLY.
•Do not use on an infant or on a sleeping or unconscious person.
•Do not use on sensitive skin. Prolonged exposure may have an adverse
affect on sensitive skin –Always check the skin in contact with the heated
area of the appliance.
•Never operate this appliance if it has a damaged cord or plug, if it is not
working properly, if it has been dropped or damaged, or dropped into
water. Contact a service center for examination and/or repair.
•To disconnect, turn all controls to the off position, then remove plug from
outlet.
DANGER –TO REDUCE RISK OF ELECTRIC SHOCK:
–Do not reach for an appliance that has fallen into water. Unplug
immediately.
–Never use pins or other metallic fasteners with this appliance.
–Discard the appliance if the covering shows any sign of
deterioration, such as checking, blistering, or cracking.
–Keep dry. Do not operate in a wet or moist environment.
