TransWorld Aquatic MT-NZ3 User manual

TRANSWORLD AQUATIC ENTERPRISES INC.
OWNER’S MANUAL
NanoZapp™
3 Watt Inline Ultra Violet Sterilizer

Table of Contents
Important Safety Instructions 3—5
Parts 6
Introduction 7
Installation 8-9
Maintenance 10-11
Notes 12-13
2

A. Carefully examine the UV appliance prior to installation. Since
the lamp and quartz sleeve are fragile, they may have been
damaged during transport.
B. Do not operate the UV appliance if it has any breakage or
cracks within the lamp or quartz sleeve.
C. Do not operate the UV appliance if the UV lamp is not com-
pletely inserted into the quartz sleeve.
D. Close supervision is necessary when any appliance is used by
or near children.
E. Always unplug the unit from an outlet when not in use, be-
fore servicing, and cleaning or making adjustments to the
pump.
UV EXPOSURE: Do not operate lamp outside housing, direct
exposure to UV rays can cause temporary reddening and irrita-
tion of eyes and skin.
DANGER
To guard against injury, basic safety precautions should be ob-
served, including the following:
WARNING
READ ALL SAFETY INSTRUCTIONS
BEFORE USE.
To avoid possible electric shock, special care should be taken
since water is employed in the use of aquarium equipment. For
each of the following situations, do not attempt to repair your-
self: return the appliance to an authorized service facility for ser-
vice or discard the appliance.
3

F. To avoid the possibility of the ap-
pliance plug or receptacle getting
wet, position aquarium stand and
tank to one side of a wall mounted
receptacle to prevent water from
dripping onto the receptacle or plug.
A “drip loop”, shown in the Figure at
the right should be arranged by the
user for each cord connecting an
aquarium appliance to a receptacle.
The ”drip loop” is that part of the
cord below the level of the recepta-
cle or the connector if an extension
cord is used, to prevent water travel
along the cord and coming in con-
tact with the receptacle. If the plug or
the receptacle do get wet, DON’T
unplug the cord. Disconnect the fuse to the circuit breaker that
supplies power to the appliance. Then unplug and examine for
the presence of water in the receptacle.
G... To avoid injury, do not contact moving parts or hot parts
such as heaters, reflectors, lamp bulbs, and etc.
H. Always unplug an appliance from the outlet when not in
use, before putting on or taking off parts, and before cleaning.
Never yank the cord to pull plug from the outlet. Grasp the plug
and pull to disconnect
I. Do not use an appliance for other than intended use. The use
of attachments not recommended or sold by the appliance
manufacturer may cause an unsafe condition.
J. Do not install or store the appliance where it will be exposed
to the weather or to temperatures below freezing.
4

It is important to keep this appliance clean. Always unplug the
appliance before performing maintenance or cleaning of the
pre-filter sponge, pump, and quartz sleeve.. . Make sure hands
are completely dry before re-plugging into an electrical outlet.
In order to assure proper electrical connections and polarity,
replacement parts and servicing should be performed only by a
qualified electrician.
Please carefully read the entire “Owner’s Manual” for proper
operation procedures before proceeding with turning on this
appliance and adding livestock such as fish, corals, and inverte-
brates.
SERVICING
OPERATION
SAVE THESE INSTRUCTIONS
J. Make sure an appliance mounted within the tank is securely
installed before operating it.
K. Read and observe all the important notices on the appliance.
L. This appliance has a polarized plug (one blade is wider than
the other). As a safety feature, this plug will fit in a polarized out-
let only one way. If the plug does not fit fully in the outlet, re-
verse the plug. If it still does not fit, contact a qualified electrician.
Never use with an extension cord unless plug can be fully in-
serted. Do not attempt to defeat this safety feature.
M. If an extension cord is necessary, a cord with a proper rating
should be used. A cord rated for less amperes or watts than the
appliance rating may overheat. Care should be taken to ar-
range the cord so that it will not be tripped over or pulled.
CLEANING
5

1
2
6
5
4
3
8
7
Description Part #
Transformer Body MT-NZ-1
3 Watt UV-C Lamp
G5.3 Bi Pin Base
MT-NZ-2
Quartz Sleeve MT-NZ-3
O-Ring (Orange ) MT-NZ-4
O-Ring (Black ) MT-NZ-5
Quartz Sleeve Cover MT-NZ-6
6” - 1/2” Flexible Tubing MT-NZ-7
6” - 1/2” Flexible Tubing MT-NZ-8
PARTS EXPLODED VIEW & IDENTIFICATION
6

Thank you for purchasing the NanoZapp™, the smallest inline ultra-violet
sterilizer to date. This miniature version was specifically designed for eradicat-
ing harmful micro-organisms and unattractive green free-floating algae in
fresh & saltwater aquariums less than 30 gallons. This revolutionary UV steri-
lizer/clarifier is completely submersible, which can be placed discreetly be-
hind the filter walls of most nano aquariums without ever being seen.
The NanoZapp™ utilizes a UV-C G5.3 bi-pin lamp that is encapsulated in our
unique Quartz Sleeve that is air tight and allows for a 99% transmission rate
to efficiently neutralize disease causing pathogens. Simply, connect to your
existing pump and you are ready to go.
Innovative Algae & Disease Control
Intelligent Design
CAUTION:
Never look directly at the UV-C Lamp, ultraviolet radiation can be
harmful. Always unplug before making adjustments.
7

Installation into JBJ 28g Nano Cube Series
The NanoZapp™ is the perfect compliment to our #1 selling 28g Nano-Cube
Aquarium, enjoy the benefits of sterilization while being discreetly hidden.
1. Remove one of the pumps.
2. Measure and cut included hose
3. Connect NanoZapp to hose
4. Plug into electrical outlet.
CAUTION: Inspect UV Lamp & Quartz Sleeve
Prior to Installation.
Upon receiving this product please untighten the quartz
sleeve cover and inspect the quartz sleeve and lamp for
any damage.
Close attention should be observed to the
UV lamp & Quartz Sleeve prior to use.
Please contact your authorized dealer if your product
is found damaged.
Initial Inspection - For breakage
Do not allow children to operate this aquarium appliance. Do
not operate if appliance has a damaged cord or plug.
Note: Do Not Plug the
pump connected to the
NanoZapp back into the
Ocean Pulse Wavemaker.
Plug into a separate outlet
as the sterilizer requires a
constant flow of water.
8

Installation into a Non JBJ Nano-Cube
The NanoZapp™ was designed for
the 28g Nano Cube Aquarium. But is
so versatile that it can be used with
most nano aquariums in the market.
Each end of the sterilizer are installed
with 1/2” diameter connectors.
The total length of the NanoZapp™
is 8 inches, remove your existing
pump/hose and connect securely.
You will need to measure and cut
the included 1/2” hose.
Flow Rate: Requires a flow rate of
100-225 gallons per hour.
The Quartz Sleeve acts as a barrier between the water and the UV-C lamp to
maintain proper operating temperatures and allow for a 99% transmission rate.
Cleaning the Quartz Sleeve is crucial to the UV’s success
and should be performed monthly.
Step 1: Unplug pump and NanoZapp™ from electrical outlet
Step 2: Unscrew the black quartz sleeve cover (counter clockwise)
Step 3 : Clean any unwanted algae and debris from the outside of the quartz
sleeve.
Cleaning the Quartz Sleeve –Monthly
Note: Vinegar may be used to re-
move calcium deposits on the exterior
of the quartz sleeve. Clean residual off
before re-installing
9

Replacing the UV-C Lamp
Replacing the UV-C Lamp— 6 to 9 months
The UV-C lamp has an average life span of 5000 hours of operation. Al-
though the lamp may illuminate, it will not perform effectively for disease
control. Lamp should be replaced before it expires.
You can check the status of the lamp by an illuminated blue color at the bot-
tom of the NanoZapp™.
.
Step 1: Twist off black quartz sleeve cover (counter clockwise)
Step 2: Gently pull quartz sleeve out.
Step 3: Unplug the UV-C lamp and plug in new lamp.
10

Recommended Maintenance
Customer Service Information
For additional information or technical support, please call
us at [phone] , M-F from 9AM-5PM (Pacific Stan-
dard Time).
Model MT-NZ3
UV Lamp G5.3 PI BIN (3 Watt)
Volts/Hz AC110V/60Hz
Pump Flow: Required 100 to 225 GPH
Aquarium Capacity 30 Gallons
Life Of UV Lamp Approx. 5000 hrs
Avg. Quartz Sleeve Cleaning
Schedule
Every Month
Wavelength 253.7 nm
Dimensions 8” x 1.5” x 1.5”
11

12

13

Visit us at www.jbjlighting.com
TransWorld Aquatic Enterprises, Inc
3730 W. Century Blvd #3
Inglewood, CA 90303
Phone: [phone]
14