TREND TONN/BAT User manual

TONN/BAT TONN UPS Option or Battery Replacement Installation Instructions TG201133 Issue 2, 12-Jun-2013 1
Installation Instructions
TONN/BAT
TONN UPS or Battery Replacement
Important: Retain these instructions
These instructions shall be used by trained service personnel only
If the equipment is used in a manner not specifi ed by these instructions, the protection provided by the equipment may be impaired.
1 Disconnect Power
2 INSTALLATION
1 UNPACKING
CONTENTS
1 Unpacking .....................................................................12 Installation .....................................................................1
WARNING:
Power to TONN must be OFF when replacing the
battery, or damage will occur.)
TONN/BATTONN UPS Optionor Battery Replacement InstallationInstructions
(TG201133)
Disconnect Power
O
I
Switch OFF
2 Remove Cover
Caution:
This unit contains static sensitive devices.
Suitable anti-static precautions should be
taken throughout this operation to prevent
damage to the unit.
BS EN100015/1 Basic Specifi cation:
protection of electrostatic sensitive devices.
It is recommended that the installation should comply
with the local electrical safety installation practices (e.g.
HSE Memorandum of Guidance on Electricity at Work
Regulations 1989, USA National Electric Code).
The TONN/BAT kit can be used as a replacement battery for TONN units requiring a backup battery for back up and shutdown in
the event of power failure, or as a uninterrupterable Power Supply (UPS) for TONN (E) units. See the TONN Data Sheet (TA201127)
for details.
Important
▪If replacing a battery follow steps (1), (2), (3), (4), (5) and (6)
▪If using a a UPS follow steps (1), (2), (4) and (5)

2 TONN/BAT TONN UPS Option or Battery Replacement Installation Instructions TG201133 Issue 2, 12-Jun-2013
TONN/BAT Installation Instructions
Please send any comments about this or any other Trend technical publication to [email protected]
© 2013 Honeywell Technologies Sàrl, ECC Division. All rights reserved. Manufactured for and on behalf of the Environmental and Combustion Controls
Division of Honeywell Technologies Sàrl, Z.A. La Pièce, 16, 1180 Rolle, Switzerland by its Authorized Representative.
Trend Control Systems Limited reserves the right to revise this publication from time to time and make changes to the content hereof without obligation
to notify any person of such revisions or changes.
Trend Control Systems Limited
Albery House, Springfi eld Road, Horsham, West Sussex, RH12 2PQ, UK. Tel:[phone] Fax:[phone] www.trendcontrols.com
Trend Control System USA
6670 185th Avenue NE, Redmond, Washington 98052, USA. Tel:[phone] Fax:[phone] www.trend-americas.com
3 Remove Battery (Battery replacement only)
4 Replace Battery
5 Replace Cover 6 Dispose of Old Battery
Dispose of the old battery in accordance with all
local and national regulations.
2 INSTALLATION (continued)
WEEE Directive:
At the end of their useful life the packaging,
and product should be disposed of by a
suitable recycling centre.
Do not dispose of with normal household
waste.
Do not burn.
Undo 4 screws