TRENDnet TU2-ET100 User manual

USB 2.0 to 10/100Mbps Fast Ethernet
Adapter
TU2-ET100
4.01
ŸQuick Installation Guide (1)

Minimum System Requirements
1
Package Contents
ŸTU2-ET100
ŸMulti-Language Quick Installation Guide
ŸCD-ROM (Driver & User’s Guide)
If any of the above contents are missing, please contact your reseller.
1. Before You Start
ŸCD-ROM Drive
ŸComputer with an available USB 1.1 or 2.0 port
2. How to Install
Note:
1. Do not connect the TU2-ET100 until instructed to do so.
2. For Mac OS X (10.4~10.6) instructions, please refer to the User's Guide on
the provided CD-ROM.
1. Insert the Driver CD-ROM into your CD-ROM drive.
2. Click Run Autorun.exe (Windows 7/Vista only).
Supported Operating Systems CPU Memory
Windows 7 (32/64-bit)
Windows Vista (32/64-bit)
Windows XP (32/64-bit)/2000
1GHz or above
800MHz or above
300MHz or above
1GB RAM or above
512MB RAM or above
256MB RAM or above
Mac OS X (10.5)
Mac OS X (10.6)
Mac OS X (10.4)
867MHz or above
333MHz or above
Intel Processor
512MB RAM or above
256MB RAM or above
1GB RAM or above

4. Follow the InstallShield Wizard
and then click Finish.
5. Click Exit and remove the driver CD-ROM from your computer's CD-ROM
drive.
6. Connect the adapter to an available USB port of your computer.
7. Drivers will install automatically.
8. Connect a network cable from the TU2-ET100 to a Switch, Router or
Cable/DSL Modem.
3. Click Install Driver.
2
Internet
Modem Router
TU2-ET100
Workstation
Your installation is now complete.

TRENDnet
20675 Manhattan Place
Torrance, CA 90501. USA
Copyright ©2011. All Rights Reserved. TRENDnet.