TRENDnet TEW-634GRU User manual

Quick Installation Guide
TEW-634GRU
1.01

Table of Contents
English ......................................................................................................
Troubleshooting .........................................................................................
1
1
3
5
15
1. Before You Start
2. Hardware Installation .........................................................................
3.
.................................................................................
Configure the Wireless Router ...........................................................
4. Using the USB port ............................................................................ 9
Version 06.19.2009

Installation Requirements
Package Contents
1. Before You Start
English
1
?
?
?
?
?
TEW-634GRU
Utility CD-ROM
Multi-Language Quick Installation
Guide
Cat.5 Ethernet cable (1.5m/5ft)
AC Power Adapter (12V, 2A)
?
?
?
?
A computer with a wired or wireless network adapter properly installed
Web Browser: Internet Explorer (5.0 or higher)
Broadband Internet
Installed Cable or DSL Modem
Note:
1. Do not install the USB Control Center, connect printer to TEW-634GRU and
connect computer to the router until instructed to do so.
2. The USB Control Center must be installed on each computer in order to use
your multi-function printer or USB storage device.

English
2
Application
300Mbps wireless multimedia sharing
300Mbps Wireless N
Gigabit Router with USB Port
(TEW-634GRU)
Notebook with 300Mbps
Wireless N USB Adapter
(TEW-624UB)
Cable/DSL
Modem
Workstation with Gigabit PCI Adapter
(TEG-PCITXR)
USB Hard Drive
Internet
USB Printer
OR
Workstation with 300Mbps
Wireless N PCI Adapter
(TEW-623PI)
Gigabit

English
3
2. Hardware Installation
Note: Gather all information related to your Internet Connection before you
start. If necessary, contact your Internet Service Provider (ISP).
2. If you plan on connecting a multi-
function printer to the USB port on
the TEW-634GRU, install the
printer drivers to your computer.
Then shutdown the printer and
disconnect the printer from your
computer.
Note: Please refer to your printer's
manual for printer installation
instructions.
Cable/DSL Modem
Internet
1. Verify that you have an Internet
connection when connecting your
computer directly to the Cable or
DSL modem. Open your browser
(e.g. Internet Explorer) and type in
a URL (e.g.
http://www.trendnet.com) in the
address bar.

English
4
7. Verify that the following panel lights
are on: Power, LAN, WAN, WLAN
and USB.
6. Connect the AC Power Adapter to
the wireless router and then to a
power outlet.
5. Connect the 2dBi detachable
antennas to the TEW-634GRU.
3. Connect one end of a RJ-45 cable
to the TEW-634GRU’s WAN port.
Connect the other end of the cable
to your modem.
4. Connect one end of a RJ-45 cable
to one of the TEW-634GRU's LAN
ports. Connect the other end of the
cable to the computer's Ethernet
port.

English
5
3. Configure the Wireless Router
Note: It is recommended that you configure the Wireless Router from a wired
computer.
2. Enter the User Name and
Password, and then click Log In.
User Name: admin
Password: admin.
3. The Wizard will automatically
appear. Click Wizard if the Wizard
does not automatically appear.
4. Click Next.
1. Open your web browser, type
http://192.168.10.1 in the
Address bar, and then press Enter.

English
6
5. Enter a Password, verify the
Password and then click Next.
By default, the Password is admin.
6. Select your Time Zone and then
click Next.
7. Click Next. Note: Do not change
default settings unless it is
conflicting with your existing
hardware.
8. Configure the settings based on
information provided by your ISP.
Follow the wizard instructions to
complete the configuration.
Note: Each Internet Connection
type may have different options.

English
7
Note: It is recommended that you enable encryption on the wireless router.
Please refer to the User Guide on the User's Guide CD-ROM for information on
setting up encryption on the wireless router.
10. Click Restart.
9. Enter the desired SSID. Then click
Next. By default, the SSID is
TRENDnet634.
11. Click Close.

English
8
Your configuration is now complete.
For detailed information regarding the TEW-634GRU's configuration and
advanced settings, please refer to the Troubleshooting section, User's Guide
CD-ROM, or TRENDnet's website at http://www.trendnet.com.
Register Your Product
To ensure the highest level of customer service and support, please take a moment to
register your product Online at: www.trendnet.com/register
Thank you for choosing TRENDnet
12. Open up your browser and enter
in a URL (e.g. www.trendnet.com)
to verify that you have Internet
connection.

English
9
1. Insert the Utility CD-ROM into
your computer's CD-ROM Drive.
Note: Before installing the utility, install the printer drivers to your computer.
Then shutdown the printer and disconnect the printer from your computer.
Please refer to your printer's manual for printer installation instructions.
Install the Utility
2. Click Run Autorun.exe
(Windows Vista only).
3. Click Install Utility.
4. Using the USB port
4. Click Next.

English
10
5. Follow the InstallShield Wizard
instructions. Then click Finish.
1. Double click on the TRENDnet
USB Control Center icon.
2. Select the printer. Click
AutoConnect Printer and click
Set AutoConnect Printer.
Note: Only one user can print at a time in Auto Connect mode. Once a user
has finished printing, another user can print to the printer.
Printing
6. Connect the USB printer or USB
storage device to the USB port on
the TEW-634GRU.

English
11
5. The USB Device Control Center
will now show the printer as an
AutoConnected Printer.
7. Select the printer. Then click
Disconnect. (Optional).
Note: For Auto Connect printing, a user does not have to wait for the current
owner to click disconnect. Follow step 1 to grab ownership of the print server.
4.Click OK.
6. User can now start printing.
3. Select the desired printer and click
Apply.

English
12
3. Place the document on the Multi-
Function Printer's Scanner bed.
4. Type in a name, select image type
and choose the desired path. Then
click Scan.
2. Select TWAIN or WIA and click OK.
1. Select the printer. Click Network
Scanner.
Note: Only one user can scan at a time in Network Scanner mode. Once a
user has finished scanning, another user can scan documents.
Scanner

English
13
1. Double click on the TRENDnet
USB Control Center icon.
Note: Only one user can connect to the USB storage device at a time.
Storage
5. The multi-function printer scanner
software will appear. Follow the
scanner software instructions.
6. Repeat steps 3, 4 and 5 to scan
additional documents. Otherwise,
click Close.

English
14
4. Click Disconnect to disconnect
from the storage device.
2. Click Connect.
3. Select Open folder to view files
and then click OK.

15
Troubleshooting
Q1:
A1:
I typed http://192.168.10.1 in my Internet Browser's Address Bar, but an error
message says “The page cannot be displayed.” How can I get into the TEW-
634GRU's web configuration page?
First, check your hardware settings again by following the instructions in
Section 2. Second, make sure the LAN and WLAN lights are lit. Third, make sure
your TCP/IP settings are set to Obtain an IP address automatically (see the
steps below).
1. Go into the Control Panel, click Network and
Internet, click Network and Sharing Center,
click Manage Network Connections and then
right-click the Local Area Connection icon and
then click Properties.
1. Go into the Control Panel, double-click the
Network Connections icon and then right-click
the Local Area Connection icon and then click
Properties.
2. Click Internet Protocol Version
4(TCP/IPv4) and then click Properties.
Then click on Obtain an IP address
automatically.
2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Obtain an IP address automatically.
Windows Vista

16
Fourth, press on the factory reset button for 15 seconds.
I am not sure what type of Internet Account Type I have for my Cable/DSL
connection. How do I find out?
Contact your Internet Service Provider's (ISP) support service for the correct
information.
The Wizard does not appear. What should I do?
First, click on Wizard on the left hand side. Second, near the top of the
browser, “Pop-up blocked” message appear. Right click on the message and
select Always Allow Pop-ups from This Site. The next time to login to the TEW-
634GRU, this window will appear. Third, disable your browser's pop up blocker.
I went through the Wizard, but I can not get onto the Internet. What should I
do?
First, verify that you can get onto the Internet with a direct connection into your
modem. Second, contact your ISP and verify all the information that you have in
regards to your Internet connection settings is correct. Third, power cycle your
modem and router. Unplug the power to the modem and router. Wait 30
seconds, and then reconnect the power to the modem. Wait for the modem to fully
boot up, and then reconnect the power to the router.
I can not make a wireless connection to the Router. What should I do?
First, make sure that the antennas are connected to the TEW-634GRU.
Second, double check that the WLAN light on the Router is lit. Third, login to your
router. Enter http://192.168.10.1 into the address bar of your router. The default
user name and password is admin. Click Wireless and then click Basic. Make
sure Enabled is selected for Wireless and then click Apply. Fourth, power cycle
the TEW-634GRU. Unplug the power to the TEW-634GRU. Wait 15 seconds,
then plug the power back in to the TEW-634GRU. Fivth, contact the manufacturer
of your wireless network adapter and make sure the wireless network adapter is
configured with the proper SSID. The preset SSID is TRENDnet634.
Q2:
A2:
Q3:
A3:
Q4:
A4:
Q5:
A5:

Q6:
A6:
Q7:
A7:
Q8:
A8:
Q9:
A9:
The TRENDnet USB Control Center does not detect the TEW-634GRU. What
should I do?
First, double check your hardware connections; make sure that the TEW-
634GRU is powered ON and is properly connected. Second, disable any
software firewall programs such as ZoneAlarm or Norton Internet Security. If your
computer is running Windows XP or Vista, disable the built-in firewall. Third, go
to System -> Exit in the USB Control Center to close the program. Then double
click on the TRENDnet USB Control Center icon to open up the program. Fifth,
power cycle the TEW-634GRU. Unplug the power to the TEW-634GRU, wait 15
seconds, then plug the TEW-634GRU back in.
No window appears after I connect my computer to my storage device. What
should I do?
On Windows 2000/XP, double click on My Computer. A list of drives appears.
Double click on the drive for your storage device. On Windows Vista, click the
windows icon on the bottom right hand corner and click Computer. A list of drives
appears. Double click on the drive for your storage device.
A connect device failed error message appears when I try to connect to my
USB storage device. What should I do?
This message appears when another computer current has access to the
USB storage device. Press Request to Connect in the USB Control Center utility
and wait for the other user to accept your request. You may also get access to the
USB storage device by unplugging the power to the router and plugging the power
to the router back in. In the USB Control Center utility, click Connect. The error
message will no longer appear.
I cannot set my printer as an auto-connect printer. What should I
do?
Verify that no other computer is using the printer. In the utility, if there is a
computer name next to the printer name, another computer is using the printer.
Once the user has finished printing or scanning, you will be able to print or scan.
If you still encounter problems or have any questions regarding the TEW-634GRU,
please contact TRENDnet's Technical Support Department.
17