Triclimb AT1 User manual

Your Triclimb accessory has been CE tested as a slide and a climbing
plank/ramp. The method of connection is both simple and easy to use. No
tools are needed to connect or disconnect the accessory.
WARNING: Connecting the accessory should be attempted by adults only.
The locking connector is an important safety feature and should always be
fully engaged prior to use.
Suitable for ages 0+
Weight limit –100kg
IMPORTANT - Retain these instructions for future reference.
Dimensions –100 x 1200 x 320 (360 including joints) mm approximately.
IPO - Registered design.
Model –AT1
Designed and Manufactured by Triclimb Ltd,
8 Griffin Industrial Estate, Penrhyndeudraeth, Gwynedd, Wales, LL48
6LE www.triclimb.co.uk [email protected]o.uk
CARE INSTRUCTIONS
Caring for your Tri Climb accessory is not only essential for improving safety
but will also add years to its life for your children to play on and enjoy as
they grow.
WARNING: if the checks and maintenance of the accessory are not carried
out the activity toy could overturn or otherwise become a hazard.
*All bolts and fixings should be checked regularly and tightened if
necessary.
*It is important to check your accessory for wear and damage regularly. If
you are unsure as to the integrity of any component, replace it
immediately.
*We recommend that you regularly check your accessory for splits, broken
or cracked wood, missing, loose or sharp-edged hardware –replace, tighten
and/or sand smooth as required prior to playing.
*The wooden components are manufactured from FSC birch plywood and
solid timber poles; they are protected with a durable child/toy-safe finish.
*To clean, wipe with a damp cloth and mild detergent. Dry immediately.
Leaving water or cleaning agent on the surface may damage the finish. Do
not use abrasive cleansers.
* Do not modify the unit. Triclimb Ltd is not responsible for any injury
arising as a result of modifications made by customers to our products
without our supervision, testing, or evaluation.
Tri Climb – Attachment
*Reversible Activity board (slide/plank)
Tri Fix joint system

Connecting your attachment
Prior to use you must ensure you lock the attachment in place using our
specially designed locking method to ensure it does not move whilst in use.
Simply –LIFT –SET –DROP
1) Lift one side of the Triclimb off the floor by a few inches.
2) Carefully bring the attachment to the desired rung and hook the
shallow cutouts over the rung as shown in figure 2
3) Gently drop the Triclimb to the floor and the accessory will become
locked in position.
REMOVING the accessory is the reverse of connecting.
WARNINGS
*It is extremely important that you read and retain the information in this
WARNINGS section to reduce the risk of injury.
*Always ensure the attachment is correctly secured in place prior to use
*Children must be supervised at all times while using the Tri Climb attachment.
*No running, pushing or fighting.
*Only use the attachment for its intended purpose. For indoor use only, in a
domestic setting.
*Tip over hazard - Place play-frame on a level surface.
*Keep floors free of trip hazards and observe an obstacle free safety zone of at
least 2m in all directions around the unit.
*To minimise risk of injury from falling, do not install over a hard surface; a
protective surface should be used. Maximum vertical fall height - 590mm
*Never allow children to play with ropes, clotheslines, pet leashes, cables, chains
or cord-like items when using this play-frame attachment or to attach these items
to the play-frame.
*Never allow children to wear loose fitting clothing, ponchos, hoods, scarves,
capes, necklaces, items with draw-strings, cords or ties when using this Tri Climb
attachment.
*Do not allow children to wear open toe or heel footwear like sandals or flip–
flops whilst climbing.
*Do not permit rough play or use of equipment in a manner for which it was not
intended.
*Observe capacity limitations of your play-frame - 1 user maximum.
*Recommended age: 0+ months
*Weight limit –100kg
*Risk of entrapment connecting - Never allow children to connect or disconnect
the attachment.
WARNING –When using the accessory as a SLIDE it must not be placed
on the very top rung of the Triclimb. It must be connected between two
rungs with one rung above and one rung below in order to lock.
2
3
1