Tripstix ClustAir User manual

USER MANUAL
ClustAir Boards

fin key (if needed
for fin setup)
valve keys
valve
adapter
strap
fin (s)
INCLUDED
Thruster Board
kick tail
handle
deck pad
valve / relief valve
Thruster
leash mount
Singlefin Board
Single Fin
US Box
leash mount
bungee tie down
bungee tie down
handle
deck pad
FCS fin box
valve / relief valve
BOARD TYPES

Use the fin key, to tighten the
screws. Do not tighten too strongly,
as this may cause a damage to the
finbox.
2
Put the fins into the finboxes.
The fins must point backwards and
the TRIPSTIX-Logo must face to the
outside. The centerfin does not have
a logo.
1
Thruster
Position the square nut
underneath the hole in
the fin base and tighten
the screw.
3
Put the single fin into the
finbox. To do so, insert
the pin of the fin into the
fin box and push the fin
backwards.
2
Put the square nut into
the fin box and slide it
to the front part of the
box.
1
Single fin
INSTALLING FINS
Detach the hose and close the
valve cap.
4
Open the valve cap and make
sure that the yellow pin is in
the UP position (push and turn).
2
Insert pump hose into the valve and
inflate to pressure written on the
valve ring. Take extra care when
using a compressor for inflation.
We assume no liability for
the use of a compressor.
3
Unfold the board.1
HOW TO INFLATE THE BOARD

Close the strap to fix the
package.
7
Take care not to brake the
valve cap when doing the
last fold.
6
Start folding from the tail,
until you reach the valve.
4
Continue with folding
from the nose.
5
Open the valve cap. Push
and turn the yellow pin
so that it remains in the
DOWN position.
(push and turn)
3
Remove the fins. Release the screws and pull the fins to do so.
2
Clean and dry the board. Especially take care that no sand or dust remains at the valve.
1
HOW TO DEFLATE THE BOARD
• Do not expose to direct sunlight for an extended period of time.
• Prevent overheating!
• Do not use a compressor for inflation.
• Avoid contact with sharp obstacles.
• store at a dry place with room temperatur
• if possible, store the board inflated at low pressures (3-5PSI)
• clean and dry before packing
• Do not use aggressive chemicals for cleaning. (Soap-)water can be used for cleaning.
• tighten the valves from time to time
MAINTENANCE

FEEL FREE TO CONTACT US
WEB: www.tripstix.de
MAIL: [email protected]
Singlefin (US Box)
Fins (FCS)
Leash
Pump
Shirt
Paddle
ACCESSORIES
• Always wear an approved PFD (personal flotation device).
• Do not paddle under the influence of drugs or alcohol.
• Wear a helmet when appropriate.
• Do not paddle alone. Always inform someone of your paddling expedition.
• Children must be supervised by an adult at all times.
• Check weather conditions and dress accordingly.
• Beware of winds and currents.
• Do not exceed your paddling ability; be aware of your limitations.
• Be aware of safe river water levels, tidal changes, currents, and obstacles in and
above the water.
• Check your equipment for damages prior to each use.
• Always wear a leash. Use a safety leash when paddling on rivers.
• Do not paddle in flood conditions.
• Do not paddle into protected areas (bird or fish protection etc.).
• This products contains synthetic materials like PVC, PES and EVA. Please dispose the product in an
environmental friendly manner at a designated institution.
SAFETY