TROLL nursery SUN COT User manual

The illustrations in these instructions are to be used as a guide only
Conforms to standart EN 716-1&2:2008
Made in Latvia
IMPORTANT
RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
SUN COT

INSTRUCTIONS FOR THE SAFE USEINSTRUCTIONS FOR THE SAFE USE
Your child’s safety is your resposibility.
.
and use only spare parts
approved by the manufacturer.
or place close to another product
maximum
Mattress base length and width shall be such that the gap between the mattress and the
sides and ends does not exceed 30mm.
20 6
and retighten as necessary.
To prevent injury from falls, when the child is able to climb out of the cot, the cot shall no longer
be used for that child.
WARNING : Do not use more than one mattress in the cot.
Remove all parts from packaging and check against the parts list.
Do not discard any packaging until you are sure you have all parts and the pack of fittings.
You will find it easier to assemble the cot if a second adult is available to help you.
One end of the cot has a mark indicating the height of the mattress.
The thickness of the mattress must not reduce the internal depth from mattress surface to
top of the cot side above it to less than 500 mm in the lowest position and 200 mm in the
highest position of the mattress base.
The lowest mattress base positions is the safest and should always be used as soon as the
baby is old enough to sit up.
The recommended mattress size for the cot is 1 x 0 cm.
Check regularly to ensure that all the components are secure
To clean use a damp cloth, avoiding the use of strong detergents or abrasives.
WARNING : Be aware of the risk of open fires and other sources of strong heat, such as
electric bar fires, gas fires etc in the near vicinity of the cot
WARNING : Do not use if any part of the cot is broken, torn or missing
WARNING : Do not leave anything in the cot , which could
provide a foothold or present a danger of suffocation or strangulation e.g. strings,
blind/curtain cords etc.

PARTS LISTPARTS LIST
FITTINGS LISTFITTINGS LIST

ASSEMBLING
WARNING! op
surface be higher
than this mark!
The t of the mattress
must not
Attach ends to cot’s legs
using screws Ax8.
Do not tighten.
Insert screws Bx4 for fitting
mattress base in one of
three height positions.
Attach sides to ends
using screws Ax8.
Do not tighten.

Drop mattress base onto screw
in dowel pins. Tighten the cams
on front underside of mattress
base using a crosshead
screwdriver.
Securely tighten all allen-head bolts.