Tronix 214-175 User manual

S1 S2
S3
S1 S2
S3
S1 S2
S3
RF Dual Color Remote Controller 09.289ST.04165
Function introduction
Important: Read All Instructions Prior to Installation
Output RF signal
Operation Frequency 869.5/916.5/434MHz
Operating temperature 0-40°C
Relative humidity 8% to 80%
Dimensions 120x55x17mm
Front side
Bottom side
• Control 4 zones of RF receivers separately.
• CCT color controller
• High sensitive & high stable, fast & precise color control.
• Compatible with all universal series RF receivers
• 1 receiver can be paired by max 8 different remote controls.
• Waterproof grade: IP20
Product Data
Safety & Warnings
Power Supply 4.5V(3xAAA battery)
Indicator: indicate the
state of remote control
Touch color wheel, touch to select
color temperature
Press and hold down to
increase/ decrease light intensity
75% brightness 100% brightness
25% brightness 50% brightness
Click to turn ON/OFF all zones
Press and hold down to save colors;
Click to recall the saved colors
Zone numbers:Click to choose
the zone/zones, Press and hold
down to turn on/off corresponding
zone
4.5V(3xAAA battery)
• This device contains AAA batteries that shall be stored and disposed properly.
• DO NOT expose the device to moisture.
Pair with RF receiver(Method 1)
Step 4:Choose and click a zone number(e.g. zone 4)
Step 3:Click the “Learning Key” button on RF receiver or re-power on the receiver
three times continuously to set it into pairing status
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 5:Touch the color wheel, LED lights connected with the RF receiver flicker
once means the receiver is paired with zone 4 successfully.
Step 2:Click ON/OFF button to activate the remote
Pair with RF receiver(Method 2)
Step 4:Choose and click a zone number(e.g. zone 4) twice, then press and hold it
continuously and quickly within 10 seconds, LED lights connected with the RF receiver
flicker once means the receiver is paired with zone 4 successfully.
Step 3:Power off and power on the receiver
Learning Key
RF LED Receiver
Step 1:Do wiring the RF receiver according to wiring diagram(please refer to the
instruction of RF receiver that you would like to pair with.
Step 2:Click ON/OFF button to activate the remote

S1 S2
S3
S1 S2
S3
Save color/scene/mode
Step 2:Choose and click one or multiple paired zone numbers(e.g. zone 4)
Step 1:Click ON/OFF button to activate the remote
Step 3:Touch the color wheel or click the other buttons to select the scene
you like
Recall the saved colors/scenes
Step 2:Choose and click one or multiple paired zone numbers(e.g. zone 4)
Step 1:Click ON/OFF button to activate the remote
If you use multiple receivers, you have two choices:
Option 1: have all the receivers in the same zone, like zone 1
Lear nin g Key
RF LED Re ce iv er
Zone 1
Option 2: have each receiver in a different zone, like zone 1, 2, 3 or 4
Zone 1 Zone 2 Zone 3
RF remote
RF remote
Lear nin g Key
RF LED Re ce iv er
Lear nin g Key
RF LED Re ce iv er
Lear nin g Key
RF LED Re ce iv er
Lear nin g Key
RF LED Re ce iv er
Step 4:Press and hold any scene buttons of S1-S3(e.g. S3) , LED lights connected
with the RF receiver flicker once means the color/scene was saved successfully.
Step 3:Click any scene buttons of S1-S3(e.g. S3) to recall the saved scene