Wiring Diagram &
Schematic
SAFETY WARNINGS
Safety Alert Symbols
The safety alert symbol ( ) is used
to identify hazards that can result in
personal injury. A signal word
(DANGER, WARNING or CAUTION)
is used with the alert symbol to
indicate the potential severity of
injury. In addition, a hazard symbol
may be used to represent the type
of hazard.
DANGER: Indicates a hazard
which, if not avoided will
result in death or serious
injury.
WARNING: Indicated a
hazard which, if not avoided
could result in death or
serious injury.
CAUTION: Indicates a
hazard which, if not avoided
might result in death or
serious injury.
HAZARD SYMBOLS AND MEANINGS
EXPLOSION FIRE SHOCK
ENTANGLEMENT
DISCONNECT
SPARK PLUG
DANGER
IMPORTANT: The measuring
equipment used in troubleshooting
this equipment should be of
industrial quality and should have
the sensitivity to measure electronic
values to the third decimal. Its
accuracy should conform with
acceptable industry tolerances.
Ensure that all specified tools
and/or equipment are available
before attempting to troubleshoot.
Generators produce powerful
voltages. Failure to isolate
generator from power utility can
result in death or injury to electric
utility workers due to
backfeed of electrical energy.
• When testing generators used for backup
power, notify utility company.
DANGER
Physical contact with energized
electrical components will result
in dangerous and possibly fatal
electrical shock
•Do not touch bare wires or
receptacles.
CAUTION
These wiring diagrams and
schematics are intended for use
by trained and qualified electrical
service technicians who are
working in a properly equipped
service environment. Familiarity
with the proper method of using
tools, measuring equipment and
service procedures is essential to
performing successful
troubleshooting and repair of this
equipment.
•Only qualified electrical technicians
should attempt to service this
equipment.
Accidental starting of the unit
may cause entanglement or
electrocution
•Where applicable, disconnect the
negative (-) battery terminal
•Disconnect the spark plug wire.
•Remove the control panel fuse when
available.
Rev. 02162007
WARNING
