True Induction TI-1SS User manual

1
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS
240V 3500 WATT COMMERCIAL SINGLE
INDUCTION COOKTOP OPERATION MANUAL

2
I.
II.
III.
IV.
V.
Important safety Information
Control Panel
Cleaning & Maintenance
Compatible Cookware
Troubleshooting Error Codes
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS
TABLE OF CONTENTS
1-2
3-5
5
6
7

3
I. Important Safety Information
 Do not touch ceramic glass plate surfaces while or after cooking, ceramic glass surface will
become hot from heat generated by cooking pan.
 To protect against electrical shock do not immerse cord, plugs, or appliance in water or any
liquid.
 Close supervision is necessary when induction range is being used. Operator must be
properly trained on all operational and safety procedures, especially when using near chil-
dren.
 Unplug unit when not in use and before cleaning. Allow unit to cool before moving or clean-
ing.
 Do not operate the appliance with a damaged cord or plug or after the appliance malfunc-
tions or has been damaged in any manner. Call our customer service for assistance.
 The use of any accessories or cooking pans, which are not recommended by the manufac-
turer, may cause injuries.
 Do not use outdoors, indoor use only.
 Do not allow power cord to hang over edge of table or counter, or touch hot surfaces.
 Do not place the induction range in, on, or near open ames, electric burners, heated ovens,
or other high temperature equipment or surroundings.
 To disconnect, turn o all controls, then gently remove plug from wall outlet.
 Do not use induction range for anything other than cooking with suitable pans and subver-
sion.
 Do not immerse induction range in water, as this will cause permanent damage to unit.
CAUTION!
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.1
When using electrical appliances, basic safety precautions should always be followed.
DO NOT operate induction range if unit appears damaged or malfunctions in any man-
ner. Call customer service for assistance.
Read all instructions and be properly trained before operating induction range.

4
I. Important Safety Information Continued...
 Do Not Use if ceramic glass cook top should break or crack, as cleaning solutions and spillo-
vers may penetrate the broken cook-top and could create an electrical shock risk.
 Before Cleaning Ceramic Glass Plate Surface – Unit must be unplugged and cool to touch.
Wipe ceramic glass plate with damp cloth and only use a non-abrasive glass cleaning solu-
tion on spills.
 Caution - To ensure continued protection against risk of electric shock, connect to properly
grounded outlets only.
 Do not heat any empty pans or pots as this will automatically activate the over heating pro-
tection device and shut o unit. Never heat any sealed metal cans on induction range as
this could cause them to explode and unit to shut down.
 Do not place metallic objects such as knives, forks, spoons, lids, cans and aluminum foils on
or near the top glass plate.
 Allow sucient space around the cooking area and always place unit on level at surface.
Do not block the air-intake panel as this may cause unit to overheat. Keep unit a minimum
of 4” from wall or other equipment or obstructions for proper ventilation.
 Never use or place the unit on low-heat-resistant or ammable materials (carpet, vinyl, pa-
per, or fabric).
 Do not ever place any paper between the cooking pan and cooking plate. The paper could
ignite.
 When storing, DO NOT place any objects on top of the induction range. This could cause
damage to cooking surface or unit.
 Any Items with a magnetic eld, such as: radios, televisions, automatic-banking cards and
cassette tapes, can aect the unit.
 People with pacemakers should stand a minimum of 30” from unit while in use.
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.2

5
I. Control Panel
Overview
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.3
1. Cooking Zone
2. Ceramic Glass
3. Stainless Steel
4. Control Panel
5. Time Selection
6. Reduce Time, Temperature or
Power
7. LED Display
8. Increase Time, Temperature
or Power
9. Heat, Temperature, and Timer
indicator lights
10.Temperature Button
11.ON/OFF Button
12. Heat Button
13.Power Indicator
2
1
3
4
12
13
5678910 11

6
II. Control Panel Continued...
Installation & Operation
For installation maintain a distance of 10CM (5 inches) between the appliance and walls or oth-
er objects.
NOTE: NEVER PLACE EMPTY COOKWARE ON THE COOKTOP.
1. Connect the appliance to the mains power supply. A beep will sound and the display will
briey light up.
2. Place suitable cookware on to the center of the glass plate.
3. Press the ON/OFF button to turn on the cooktop.
4. Press the WATTS or TEMP button depending on your cooking needs.
NO NOTE: If you wish to maintain a constant temperature during cooking, use the
TEMP settings. To cook at a specic power, use the HEAT settings.
5. Press the UP or DOWN button as needed to reach the desired setting.
150°F, 160°F, 170°F, 180°F, 190°F, 200°F, 210°F, 220°F, 230°F, 240°F, 250°F, 260°F, 270°F,
280°F, 290°F, 300°F, 310°F, 320°F, 330°F, 340°F, 350°F, 360°F, 370°F, 380°F, 390°F, 400°F,
410°F, 420°F, 430°F, 440°F, 450°F. The defaults is 270°F.
400W ,600W, 800W, 1000W, 1200W, 1400W, 1600W, 1800W, 2000W, 2200W, 2400W,
2600W, 2800W ,3000W, 3200W, 3500W. Total 16 level. The defaults is 1600W.
6. Press the TIMER button . “0” appears on the display.
7. To set the cooking time, press the UP or DOWN button as needed to reach the de-
sired time frame. The time can be set in 5 minute increments up to a maximum of 150 minutes,
which then counts down in 1 minute increments.
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.4
!
!

7
II. Control Panel Continued...
Installation & Operation
NOTE: During cooking the TIME/HEAT/TEMP can be adjusted at any time.
8. A beep will sound when the cooking time has nished, and the cooktop will switch to
standby mode.
9. After cooking is completed, press the ON/OFF button to turn o the cooktop.
III. Cleaning & Maintenance
Please follow these directions along with important safety steps for cleaning advised at the begin-
ning of the manual:
 Before cleaning always switch OFF the device and wait for it to be completely cool. Clean the unit
after each use to remove food residues.
 Wipe o the glass-ceramic plate and the plastic surface with a slightly damp cloth (mico-ber
works best). Dishwashing soap may be used when necessary.
 Make sure that no water seeps into the device. Never use abrasive cleaners (i.e. metal pads) or
oil-based liquids. Never run the cooktop under water.
 A vacuum cleaner attachment may be used to suck up dirt from the air intake and exhaust vent.
!
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.5

8
IV. Compatible Cookware
Induction requires pots and pans that are made of ferrous (meaning magnetic) materials. Check
your cookware's retail box for the induction symbol. To tell if your current cookware is compati-
ble with the induction technology, grab a magnet and see if it holds. If your magnet stays then
your cookware is ready to be used on the True Induction double burner induction portable
cooktop!
Optimal cookware has a flat bottom and a diameter of 4.72" - 10.24" inches. Round, flat bottom
pans give the best results. Pans with warped or curved bottoms will not heat evenly. For wok
cooking, use a flat-bottom wok. Do not use a wok with a support ring. Look for this induction
image on the retail box:
The following are NOT COMPATIBLE:
 Heat-resistant glass, ceramic, copper, aluminum pan/pots, round bottomed cookware, or
cookware with a base less than 4.72 inches.
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.6

9
V. Troubleshooting Error Codes
If the display shows an error code, please reference this sheet for a potential solution:
240V 3500 WATT COMMERCIAL SINGLE INDUCTION COOKTOP MANUAL TI-1SS P.7
Internal circuit error. Contact manufacturer
Top plate over heat. Please turn off the cooktop to let it cool down.
No cookware found or improper placement of cookware on cooking
zone. Ensure ． cookware is centered on cooking zone and that it's
induction compatible -see COMPTIBLE COOKWARE
IGBT (insulated Gate Bipolor Transistor) overheating. Turn off the unit to
allow IGBT to cool Restart unit once cooled.
Supplied voltage to cooktop is too high. This may occur when there is an
increase in voltage supplied to the house circuit. Once the supplied
voltage returns to normal, the code will disappear.
Supplied voltage to cooktop is too low. This may occur when there is an
increase in voltage supplied to the house circuit. Once the supplied
voltage returns to normal, the code will disappear.
Top plate sensor open/short circuit. Turn OFF the cooktop: then shut off
power at the circuit breaker for 30 secs. Turn the power on and press
POWER button to the unit. If error message persists, call for service.
IGBT sensor open circuit/short circuit. Turn OFF the cooktop: then shut
off power at the circuit breaker for 30 secs. Turn the power on and press
POWER button to the unit. If error message persists, call for service.
Error Code
E1
E2
E3
E4
E5
E6
E7
- - - -
Cause and Potential Solution