True TurboSpeed TCG220-T Manual

Set up Wireless for TurboSpeed TCG220-T
Set up 802.11Band and Channel
1. Type 192.168.1.1 then press Enter, type Username = admin,
Password = password and press Login

2. On top, click Wireless > Radio, set up as follows:
Wireless Interface : choose to set Wireless channel, select Mac
Address and at 802.11 band, check to see if it is 2.4GHz or
5GHz
Wireless : Enabled
Bandwidth : 2.4GHz should select 20MHz, 5GHz should select
20 or 40MHz
Control Channel : select Auto but can change it to avoid
overlapping with other Wireless Channel by using Scan
Wireless APs button
Click Apply

Set up SSID and Security
1. On top, click Wireless > Primary Network
Primary Network : Enabled
Network Name (SSID) : enter network name
Select Enabled at WPA-PSK and WPA2-PSK
WPA/WPA2 Encryption : AES
WPA Pre Shared Key : set password to use Wireless
(click Show Key to see the password typed)
WPS : choose WPS or Disabled depending on usage. Press
WPS button to use Wireless and select WPS
Scroll bar down to next page

2. It is not recommended to set up WEP since it’s old Security
system, click Apply

Set up MAC Filter
1. On top click Wireless > Access Control > MAC Restrict Mode
Disabled : do not use this function
Allow : allow the access only specific MAC Address
Deny : not allow the access only specific MAC Address
Enter MAC Address and click Apply, that MAC Address will
appear in table

Set up WDS
1. On top, click Wireless > Bridging > Wireless Bridging then select
Enabled to set up WDS by entering Wireless MAC Address of
main Wireless Router (mostly Router should be the same brand and
model) then click Apply