TSI Instruments BLUESKY User manual

AIR QUALITY MONITOR
Quick Start Guide
BlueSky™

Inventory
You Will Need
Optional
x 1
x 1 x 1
x 1
x 1
x 2
Four (4) screws are required
(not supplied) if installing on
wall, fence, wood board, etc.
x 4

1) Set Up
1)
To configure BlueSky monitor wireless settings,
slide switch towards the settings gear icon.
Status LED light will flash 1 time/second.
Connect power
supply (USB end)
to BlueSky™ Air
Quality Monitor.
Connect power
supply (other end)
to a power outlet.
2)
3)
5V 5W

Connecting your BlueSky
monitor to the Wireless
(Wi-Fi) network:
Open a web browser on your
computer/phone/device and
type 192.168.4.1 into the URL
address field. When prompted,
enter your Wi-Fi Network Name
(SSID) and password, then save.
Note: If using a mobile device,
make sure mobile data is
turned off.
Note: Then network needs to be
a wireless network with access
to the Internet. The BlueSky
monitor will use this network
to connect to the cloud.
Enter unique password
(aka Network Security Key
or PWD on label), which
is provided on the
BlueSky label.
Place label here
Accessing your
BlueSky™ Air
Quality Monitor:
Open computer/phone/device
wireless settings. Connect to
BlueSky network.
4)
5)
6)
Type
192.168.4.1
into web
browser
Wi-Fi Network Saved
Please move switch to operate position

Move switch to close configuration
settings (away from settings gear icon).
Wait 60 seconds.
Success
The BlueSky™ Air Quality
Monitor is successfully
connected to the cloud
when the status LED light
flashes 1 time/2 seconds.
Trouble Shooting
A) Incorrect Wi-Fi network
name or password:
2 flashes/second
B) No Internet: 3 flashes/second
Please note that, as long as the BlueSky monitor
is not in setup/configuration mode, data will be
automatically saved to the pre-installed SD card.
Once the SD card data capacity is reached, it will
begin overwriting data.
To Resolve:
Go back to step 3.
Visit www.tsilink.com to sign up for an account and register
your product using the serial number.
7)
8A)
8B)
9)

2) Install
1)+ + +
2)
3A)
3B)
4)
To install on wall, fence,
wood board, etc.
To install on pole
Feed plastic ties through slots in bracket. Slip USB
cord between plastic tie and bracket, secure.
Connect BlueSky™
Air Quality Monitor
to power outlet. Status
LED light will flash
1 time/second
when successfully
connected.
p/n 5002493 Rev A
x 4
x 1
5V 5W