Tsun TSOL-RSD-S600 User manual

12 3
Quick Installation Guide
TSOL-RSD-S600/1000/1200/1500-x
Step 1: Assemble the hangers
Assemble the two hangers on the Enclosure.
Step 2: Fix the rapid shutdown control unit
Fix the rapid shutdown control unit on the wall or
the solar bracket. The size of these holes is Φ5 mm.
Warning:The rapid shutdown control unit may not be
installed in direct sunlight.
Warning: Installers should determine the installation
location of rapid shutdown control unit according to local
regulations
Tips: There are no installation screws in the package.
Installer should prepare these screws or expansion bolts
according to the installation environment.
Step 3: Connect the ground cable
Connect the ground cable to the enclosure.
Step 4: Connect the AC cable
Separate the AC connector.
Connect the AC cable. The definition of the port is
shown below:
Port 1(Brown/Red): Live
Port 2(Yellow-Green): Ground
Port 3(Blue/Black): Neutral
Tips: Use AWG 18 (or 1 mm2) cable for AC cable.
Warning: Make sure each cable is connected to the right
port.
Assemble the AC connector.
Plug the connector into the AC socket of rapid
shutdown control unit. Then connect the other side
of AC cable to an AC breaker or an AC switch.
Warning: To prevent electrical hazards, make sure the
switch is turned to “OFF” position.
Warning: Installers should determine the installation
location of switch according to local regulations
Tips: There are no AC switch or AC breaker in the package.
Paste the warning label near the switch.

4 5 6
Step 5: Connect the DC cable
Separate the DC connector.
Connect the DC cable.
Tips: Use AWG 12 (or 4 mm2) cable for DC cable.
Assemble the DC connector.
Plug the connectors into the DC sockets of rapid
shutdown control unit.
Step 6: Connect the FB1&FB2 port (Optional)
Use the 2-port connecter to connect the FB1&FB2
port to any remote status display device (such as
indicator lights). When the switch is turned on, the
FB1&FB2 will be connected. When the switch is
turned off, the FB1&FB2 will be disconnected.
Step 7: Start the rapid shutdown control unit
Turn the switch of rapid shutdown control unit to
“ON” position. The rapid shutdown control unit will
start to work and the status LED will be solid red.
Annex: Packing List
Model TSOL-RSD-S600/1000/1200/1500-
1 2 3 4 5 6 7 8 9 10
Rapid
Shutdown
Control
Unit
1
Hangers 2
Screws 4
DC
Connector
(Female)
2 4 6 8 10 12 14 16 18 20
DC
Connector
(Male)
2 4 6 8 10 12 14 16 18 20
AC
connector
1
2-port
connector
1 (optional)
Screwdriver 1
Warning
Label
1
Quick
Installation
Guide
1
TSUNESS Co., Ltd
TEL: [phone]
E-mail: [e-mail] | www.tsun-ess.com
Add: Building E1, No. 555, Chuangye Road, Dayun Town,
Jiashan County, Jiaxing City, Zhejiang Province, China