TUHOME Furniture VARESE ALB5605 User manual

VARESE PANTRY CABINET
Mueble Alacena Varese
Alto: 160,7 cm
Ancho: 70 cm
Fondo: 36 cm
Height: 63,27 in
Width: 27,56 in
Depth: 14,19 in
REF./SKU. ALB5605
LOT N°
ASSEMBLY INSTRUCTIONS
INSTRUCCIONES DE ENSAMBLE
OUR CUSTOMER SERVICE TEAM WILL PROVIDE
YOU HELP TO RESOLVE ANY ISSUES IMMEDIATELY
IF ANY PARTS ARE BROKEN OR MISSING PLEASE
CONTACT US AT: 1-888-391-01-66 /
[email protected]

!
WARNING
!
Page 2
IMPORTANT
RECOMMENDATIONS RECOMENDACIONES IMPORTANTES
No pintar el mueble.
El mueble debe ser usado únicamente en interiores,
no exponer al sol directo.
Limpiar los herrajes metálicos con un paño seco.
NO sobrecargar el mueble (ver las cargas sugeridas).
No golpear ni martillar el mueble (solo cuando se
indique).
Limpiar con un paño ligeramente húmedo,
usar jabones suaves.
No arrastre el mueble, levántelo entre dos personas.
Evite el contacto directo con el agua, el fuego o la
exposición a fuentes de calor.
Do not paint the cabinet.
The cabinet MUST be used exclusively indoors,
do not expose to direct sun.
Clean metallic hardware with a dry cloth.
Do NOT overload the cabinet (see suggested loads).
Do not hit or hammer the cabinet (just when
indicated).
Clean with a slightly damp cloth, use gentle soaps.
Do not drag, lift and move between two people.
Avoid direct contact with water, fire or exposure
to heat sources.
Never allow children to climb or manipulate
the cabinet, furniture tip over can cause
serious injuries or death.
ADVERTENCIA
!
Nunca permita que los niños escalen o
manipulen el mueble, la caída de este
puede provocar lesiones graves o la muerte.

REQUIRED TOOLS* HERRAMIENTAS NECESARIAS*
Page 3
*Not included, and not shown actual size. *No incluidas y no se muestran en tamaño real.
INDEX ÍNDICE
Assembly Hardware
Assembly Parts
Suggested Loads
Assembly Recommendations
Assembly Steps
Warranty
4
5
6
6
7-18
19
Herrajes para Armado
Piezas de Armado
Cargas Sugeridas
Recomendaciones de Ensamble
Pasos de Armado
Garantía
4
5
6
6
7-18
19

x18
Minifix Cams
Minifix
Spreading Bolt
Perno Minifix
x18x68
Wood Dowel
Tarugo
x2
Glue
Pegante
Cover Caps
Tapa Adhesiva
Minifix
x18
ASSEMBLY HARDWARE HERRAJES PARA ARMADO
Page 4
Please check that the hardware content is correct.
If any item is missing, please call to our customer
service line.
Hardware items are NOT shown actual size. Los herrajes no se muestran en el tamaño real.
Compruebe que el contenido de los herrajes sea
el correcto. En caso de que falte alguna pieza, por
favor llame a nuestra línea de atención al cliente.
x2
Handle
(Screws Included)
Full Overlay Hinge
(Screws included)
Bisagra Parche
(Incluye Tornillos)
x7
Manija
(Tornillos Incluidos)
Perfil H/
Guide Profile
x1
x6
Deslizador Puntilla
Nail-on Glide
x3
Tubo de Aluminio
Aluminium Tube

ASSEMBLY PARTS PIEZAS DE ARMADO
Page 5
B
A
D
E
L
M
C
N
F
J
H
I
K
G
PD
PI
D
G
N
N
M
H
I
A - x1
B - x1
C - x1
D - x2
E - x1
F - x1
G - x2
H - x2
I - x2
J - x1
K - x1
L - x1
M - x2
N - x3
PD - x1
PI - x1

MAX SUGGESTED LOADS CARGAS MÁXIMAS SUGERIDAS
ASSEMBLY
RECOMMENDATIONS RECOMENDACIONES DE ENSAMBLE
Page 6
Two people are recommended to assemble
the product.
Assemble the cabinet on a flat, smooth
surface, preferably on a carpeted floor
or the carton box of the product.
Carefully read the assembly instructions
and identify every wood and hardware
part before start assemblying the cabinet.
Ensamble el mueble entre dos personas.
Ensamble el mueble sobre una superficie
plana y lisa, preferiblemente sobre un
tapete o el cartón de la caja
Lea cuidadosamente las instrucciones e
identifique todas las piezas y herrajes
antes de empezar a armar el mueble.
15 Kg
33 lb
17,6 lb 8 Kg
17,6 lb 8 Kg
17,6 lb 8 Kg
17,6 lb 8 Kg
4,4 lb 2 Kg
4,4 lb 2 Kg
4,4 lb 2 Kg

1
Page 7
2
Full Overlay Hinge
Bisagra Parche
1
2
Gently hit to adjust.
Repeat this process
in the following steps
Golpee suavemente
para ajustar. Repita
este proceso en
los pasos siguientes.
B
Dx2

Page 8
3
4
E
Nx3

Page 9
6
Turn minifix cams to
the right to tighten.
Gire las cajas minifix
hacia la derecha para
apretar las piezas.
2
1
Rotate 180° /
Gire 180°
Gently hit the pieces
with a rubber hammer
to adjust the joint.
Golpee suavemente la
pieza con un martillo
de goma para ajustar
el ensamble.
2
1
N
B
N
N
E
D
D
F
5

Page 10
7
8
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
Gx2
F
G
G

Page 11
9
10
Rotate to tighten.
Gire para apretar.
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
F
G
G
NN
N
E
D
D
F
N
G
B
M
M
D
E
B
GN
N
D
Slide into
the cabinet
Deslice dentro
del mueble
M
M
Join both back
panels with the
Guide Profile
Junte ambos
fondos con el
perfil en H
1
2

Page 12
11
12
Full Overlay Hinge
Bisagra Parche
C
Rotate to tighten.
Gire para apretar.
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
C
G
E
D
N
M
G
M
N
N
F
x6

Page 13
13
14
Slide into
the cabinet
Deslice dentro
del mueble
L
B
C
DE
N
N
N
F
G
A

Page 14
15
16
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
Rotate to tighten.
Gire para apretar.
A
B
C
L
D
F
E
G
N
N
N
K

Page 15
17
18
Ix2
1
2
Gently hit to adjust.
Repeat this process
in the following steps
Golpee suavemente
para ajustar. Repita
este proceso en
los pasos siguientes.
Hx2

19
Page 16
20
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
K
H
H
I
I
J

21
Page 17
22
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
J
K
I
I
H
H
2
1
Gently hit to adjust.
Golpee suavemente
para ajustar.
Rotate to tighten.
Gire para apretar.
K
J
H
I
I
H
PD

23
After you finish the
adjustment of the cams,
cover them with the
cover caps.
Después de ajustar todas
las cajas minifix, cúbralas
con las tapas adhesivas.
After you finish
assembling the cabinet,
take off the adhesive
letters.
Al terminar de armar,
desprenda las letras
adhesivas.
A
Page 18
1
5
Hinge adjustment
Height adjustment
Ajuste de altura
4
Side adjustment
Ajuste lateral
3
Depht adjustment
Ajuste de profundidad
2
Ajuste de las bisagras
A
B
C
D
E
F
G
K
M
N
N
N
PD
PI

Page 19
WARRANTY POLICY
PÓLIZA DE GARANTÍA
TUHOME Furniture will take no liability for incidental or consequential damages caused
to or by the product (This may not apply in your state).
Warranty covers materials and workmanship imperfections which impair the assembly
or correct functioning of the cabinet.
This warranty is ONLY valid for the ORIGINAL PURCHASER, it doesn’t apply if the
product has been resold, rented, etc.
To make this warranty valid you must write to our customer service email describing the
product defect, lot number and submitting your sales reciept or proof of purchase, or
contact us at our customer service line. Replaced parts will be under the product´s
original warranty coverage period. Damaged parts will become property of the
company.
There are no other warranties applicable to this product.
OUR CUSTOMER SERVICE TEAM WILL PROVIDE
YOU HELP TO RESOLVE ANY ISSUES IMMEDIATELY
We have a 3 year warranty coverage in wooden parts and 1 year warranty coverage in
hardware pieces since its manufacturing date, which you can see in the lot number
printed on the product box and the assembly instructions leaflet.
This warranty is not valid if the defects or imperfections are caused by the incorrect
following of the assembly instructions, warnings and recommendations, misuse,
intentional damage, fire or flood, or after modifications or any kind of alteration, or
repaired by someone not authorized, when it´s been assembled 3 months after the date
of purchase. These defects MUST be reported before the warranty coverage period ends.
Once the product has been assembled, the company will not be responsible for
defective and/or damaged parts.
IF ANY PARTS ARE BROKEN OR MISSING PLEASE
CONTACT US AT: 1-888-391-01-66 /
[email protected]