Tumbl Trak Addie Beam User manual

Assembly Instructions
Addie Beam
Parts:
A. Suede covered beam
B. (2) Rubber coated feet
C. (4) Screws
D. (4) Star washer
E. Allen Wrench
Parts List
Thank you for investing in the Tumbl Trak
Addie Beam. Train leaps, turns, handstands
and much more.
After opening the boxes, please check the
parts list to make sure all pieces have arrived
in good condition. If you have any questions
during this assembly process, please call cus-
tomer service at 44 (0)2921 167 949.
A.
B.
C.
D.
E.

Open box carefully and check to make sure all parts
have arrived. Flip the beam upside down and locate
the two outside screw holes on each end of the
beam. Place the feet on the beam, line up the screw
holes with the tapered holes facing up.
Use the Allen Wrench and turn screws till the
feet are tightly secured to the beam.
(2A) Insert the screw through the star washer. (2B) Place the
screws in the tapered holes connecting the feet to the beam.
Recommended Accessories
Hopscotch Mat (90cm x 3.7m)
 Multi-use mat that can be used for FUN too
 Spans the length of the beam and more
 Hopscotch Squares on one side
 White line on other side for beam skills
1.2m x 2.4m Tumbling Mat
 Spans the length of the beam
 Provides softer surface under the
Brianna Beam
Tumbl Trak recommends the use of matting to enhance safety. The following accessories can be
purchased from Tumbl Trak’s website at www.tumbltrak.co.uk or by calling 44 (0)2921 167 949.



a 
b