Tumbl Trak Orbiter User manual

Parts List
Assembly Instructions
Orbiter
Thank you for
purchasing the
Orbiter. We hope you
will enjoy years of use
of this product.
After opening the
boxes, please check the
parts list to make sure
all pieces have arrived
in good condition. If you
have any questions
during this assembly
process, please call
customer service
at 1-800-331-4362.
Parts List:
(2) Orbiter Rings
(1) Air Barrel
(2) Orbiter Rings
(1) Air Barrel
NOTE: Tumbl Trak equipment is not recommended for
the use in Parkour/Free Running related activities.
Any questions or problems, please call Tumbl Trak at
[phone]

Inflate the Air
Barrel about
1/2 way.
Step
2:
Insert the partially inflated Air Barrel into the
rings; making sure that the rings are about 2-3”
inside the outer seam of the Air Barrel.
Step
3:
Inflate the Air Barrel to
almost full and adjust
the rings. You will
want to get the rings
parallel to each other
to have it roll properly.
Step
4:
Top off the
Air Barrel
and enjoy!
Step
5:
Assembling the Rings:
Start by opening up
the Velcro flaps on
one side of the 1/2
ring. Next, set the
other 1/2 ring into
place and secure the
Velcro flaps. Repeat
until the rings are
tightly together.
Step
1:
NOTE: Tumbl Trak equipment is
not recommended for the use in
Parkour/Free Running related
activities.
Any questions or problems, please call Tumbl Trak at
[phone]

Accessories for the Orbiter
The following accessories can be purchased from Tumbl Trak’s website at
www.tumbltrak.com or by calling 1-800-331-4362.
Cradles
• Provides stabilization for the Orbiter if you do not need it to roll
Booster Blocks
• Provides a raised surface for the smaller athletes and still
allows the Orbiter to roll freely
Launch Pad
• Placed in front of the Orbiter the Launch Pad works great for
dive rolls, round-offs, and front handsprings
Jack and Jill Mats
• These mats fold up and can be used with the Orbiter to help
the smaller athlete on take off and landings
Any questions or problems, please call Tumbl Trak at
[phone]