Turf Equipment Z-Spray Series Manual

Z-SPRAY™
SetupInstructions
ForSerialNos.404,314,159&Higher
LiteraturePack
Manual,Operator's
Manual,EngineOwner
CheckingTirePressure
1.Checkthetirepressureinalltires.Properination
is18psi(124kPa).
2.Adjustifnecessary.
ServicingtheBattery
Important:Themachineisshippedwithalled
leadacidbattery.
DANGER
Chargingorjumpstartingthebatterymayproduce
explosivegases.Batterygasescanexplodecausing
seriousinjury.
•Keepsparks,ames,orcigarettesawayfrom
battery.
•Ventilatewhenchargingorusingbatteryinan
enclosedspace.
•Makesureventingpathofbatteryisalwaysopen
oncebatteryislledwithacid.
•Alwaysshieldeyesandfacefrombattery.
DANGER
Batteryelectrolytecontainssulfuricacid,whichis
poisonousandcancausesevereburns.Swallowing
electrolytecanbefatalorifittouchesskincan
causesevereburns.
•Wearsafetyglassestoshieldeyes,andrubber
glovestoprotectskinandclothingwhen
handlingelectrolyte.
•DoNotswallowelectrolyte.
•Intheeventofanaccident,ushwithwaterand
calladoctorimmediately.
1.Checkthevoltageofthebatterywithadigital
voltmeter.Locatethevoltagereadingofthebattery
inthetablebelowandchargethebatteryforthe
recommendedtimeintervaltobringthechargeup
toafullchargeof12.6voltsorgreater.
Important:Makesurethenegativebattery
cableisdisconnectedandthebatterycharger
usedforchargingthebatteryshouldhave
anoutputof16voltsand7ampsorlessto
avoiddamagingthebattery(seechartfor
recommendedchargersettings).
Voltage
Reading
Percent
Charge
Maximum
Charger
Settings
Charging
Interval
12.6or
greater
100%16volts/7
amps
NoCharging
Required
12.4–12.675–100%16volts/7
amps
30Minutes
12.2–12.450–75%16volts/7
amps
1Hour
12.0–12.225–50%14.4volts/4
amps
2Hours
11.7–12.00–25%14.4volts/4
amps
3Hours
11.7orless0%14.4volts/2
amps
6Hoursor
More
CAUTION
Iftheignitionisinthe“ON”positionthere
ispotentialforsparksandengagementof
components.Sparkscouldcauseanexplosionor
movingpartscouldaccidentallyengagecausing
personalinjury.
Besureignitionswitchisinthe“OFF”position
beforechargingthebattery.
2.Connectthenegativebatterycable.
Note:Ifthepositivecableisalsodisconnected,
connectthepositive(red)cabletothepositive
©2019—ExmarkMfg.Co.,Inc.
2101AshlandAve
Beatrice,NE68310
PartNo.4504-423Rev.A
PrintedintheUSA
AllRightsReserved*4504-423*A

batteryterminalrst,thenthenegative(black)cable
tothenegativebatteryterminal.Slipinsulatorboot
overthepositiveterminal.
Note:Iftimedoesnotpermitchargingthebattery,
orifchargingequipmentisnotavailable,connect
thenegativebatterycableandrunthevehicle
continuouslyfor20to30minutestosufciently
chargethebattery.
ServicingtheEngine
Theengineisshippedwithoil;checkoillevelandif
necessarylltotheappropriatelevel.Exmark4-Cycle
PremiumEngineOilisrecommended;refertothe
EngineOwner'smanualforanappropriateAPIrating
andviscosity.
ServicingtheHydraulicOil
Themachineisshippedwithhydraulicoilinthe
reservoir.
1.Runthemachineforapproximately15minutesto
allowanyextraairtopurgeoutofthehydraulic
system.
2.Checkhydraulicreservoirandifnecessaryllthe
reservoirtotheappropriatelevelwithExmark
PremiumHydrooil(seetheOperator’smanual).
3.Replacehydraulicreservoircapandtightenuntil
snug.DoNotovertighten.
LoweringAnti-TipBrackets
(IfApplicable)
Theleftandrightanti-tipbracketsneedtoberotated
intopositionandsecured.Removethelowerboltsand
loosenthetopboltssothebracketscanrotatedowninto
thecorrectposition.Installthelowerboltsthroughthe
bracketandframeandtightenallfourbolts.
g271767
Figure1
1.Rotateleftandright
brackets
2.Lowerbolt
RemovingZipTieonHandSpray
Gun
Somemachinesmaybeshippedwiththehandspraygun
zip-tiedtothehose.Removetheziptiebeforeuse.
InstallingtheCable/DisplayMount
Somemachinesmaybeshippedwiththecable/display
mountrotatedtotheside.
1.Removeandretainthebottombolt
g285170
Figure2
1.Cable/displaymount3.Topbolt
2.Rotate4.Bottombolt
2.Loosenthetopboltenoughtorotatethe
cable/displaymountupward.
3.Lineupthemountwiththeholeintheconsole.
4.Installthebottomboltthroughthemountandinto
theconsole.
5.Tightenthetopandbottombolt.
FillingOuttheProduct
Registration
Fillouttheonlinewarrantyregistrationform.
2