Turn Key B-SAS-3260-C User manual

60”Sit and Stand Desk(LB-SAS-3260-C/O/L/W)
Questions, problems, missing parts? Before returning to the store call
Customer Service
Time available: 8:00 am - 5:00 pm PST
Hotline: [phone]
Thank you for choosing E-Ready Furniture.
1 of 8
Assembly Instructions

2 of 8
Part List:
Part
1Desk Top 1
2
3Right Leg
Left Leg 1
1
Right bottom Panel
Description Quantity Part
41
5
Left bottom Panel
1
AC Electrical Cord Cover
61
Description Quantity
Getting to know your product
Part
H1 8
Description Quantity
Hardware List:
NOTE: Hardware not shown to actual size.
Hex Bolt
Hex Nuts
Flat Washer
Hex Cap Bolt
H2 8
H3 8
2
2
Flat Washer
H4
Part
H5
Description Quantity
Screw
Open Ended Hex Wrench
H6 18
H7 2
Connection Bar
H8 1
Nylon Cord Tie
H9 1
H1 H3 H6
H7
H8 H9
Assembly Instructions
H4 H5
H2

3 of 8
Step 1
Assembly Instructions
CONNECT DESK TOP & LEFT LEG (1) & (2) WITH (H1) (H2) & (H3).
VERTICAL

4 of 8
Step 2
Assembly Instructions
CONNECT DESK TOP & RIGHT LEG (1) & (3) WITH (H1) (H2) & (H3).USE OPEN ENDED WRENCH,
WHICH IS (H7) TO TIGHTEN ALL BOLTS.

5 of 8
Step 3
Assembly Instructions
CONNECT Left & Right LEG (2) & (3) BY INSERTING THE CONNECTION BAR (H8) THROUGH BOTH
(2) & (3) THEN ADD (H5) THE FLAT WASHER AND (H4) THE HEX CAP BOLT, AND TIGHTEN.

6 of 8
Step 4
Assembly Instructions
LOCATE THE CORD MARKER (X5) ON THE AC CORD, AND POSITION THE CORD SO THE CORD
MARKER IS LOCATED 1” FROM THE BOTTOM OF THE AC CORD CHANNEL. THEN FASTEN THE
NYLON CORD TIE (H9) AROUND THE LEG AND THE CORD. PULL THE NYLON CORD TIE TIGHT,
AND THIS WILL STOP THE CORD MOVING IN THE CORD CHANNEL. THEN SNAP IN PLACE (6)
THE LID COVER.
Cord Marker

7 of 8
Step 5
Assembly Instructions
CONNECT (4) & (5) TO THE BOTTOM OF THE TOP(1) USING (H6) THE PHILIPP HEAD SCREWS THIS
CAN BE DONE WITH A PHILIPP HEAD SCREW DRIVER OR A PORTABLE POWER SCREW DRIVER.

8 of 8
Assembly Instructions