Tyro Fornax Basic Forestry Winch Control
Manual, standard 868 MHz version
Tyro Remotes Tel: +31-(0)546-588790
Bedrijvenpark Twente 1B Fax: +31-(0)546-579490
Nederland Website: www.tyroremotes.eu
Aquarius Basic receiver
Assembly
To optimise the system’s range, we recommend placing the Aquarius receiver as high as possible and
free of metal objects. After connection and assembly, please test firs before switching on the mains
power. Always connect the Aquarius receiver to the supply source after a main fuse.
Connection is as follows:
* Connect programming wire no. 7 to the earth
Status LED receiver Signal received: flashes yellow
Registration mode: continuously lit
For technical questions about assembly, please refer to www.tyroremotes.eu
Tab ‘Support’, Aquarius receiver, FAQs.
PLEASE NOTE: All the systems have already been programmed ex works
Programming a new Fornax transmitter to the receiver
If you want to program a new transmitter to the receiver, please do so as follows:
It is not possible to program more than 1 Fornax transmitter on the Aquarius Basic or Delta
receiver at the same time.
Emergency stop (Basic-Safe)
Make sure that the Aquarius receiver is connected correctly and has power.
Switch off the Fornax transmitter.
Connect wire no. 7 with the power supply (V+) for no longer than 3 sec. (If you connect wire
no. 7 for longer than 8 sec. the registration mode is rounded off again.)
The status LED on the Aquarius receiver will now light up.
Press the on/off switch on the Fornax transmitter in the direction of the green ‘on’ symbol.
The status LED on the Aquarius receiver will now go out.
The Fornax transmitter is now programmed to the Aquarius receiver.
After programming, reconnect wire no. 7 back to the earth connection.
After assembly, cut off and insulate all the unused wires.
