TZUMI ProGlass curve Series User manual

FINISH
Use your fingers and firmly press on the screen
from center out towards the edges to remove any
air pockets.
Use the Microfiber Polishing Cloth and
polish the
screen with tempered glass on.
IMPORTANT: Once the tempered glass is fully
adhered to the screen of your phone, it cannot be
re-installed. You must discard it.
Note: If you need to reposition the tempered
glass, carefully lift up by its corner without
touching the adhesive part. Re-adjust.
Firmly press with your thumbs in the center of the
screen and watch the
tempered glass adhere to
the screen.
Remove the Applicator out from the
bottom of the phone.
www.tzumi.com
"Always There,Never Seen"
curve series
for
Galaxy S
®6
Edge
FULL SCREEN
Curved Tempered Glass
tzumi®ProGlass Full Screen GS6 Edge ITEM NO. 4319
Distributed by tzumi®INC. NY, NY, 10016 ©Copyright 2016 tzumi®
All Rights Reserved. Made In China. ProGlass is a trademark of tzumi®
Samsung and Galaxy S are both registered trademarks of Samsung
Electronics Co., Ltd. Subject to change without prior notice.

IMPORTANT: Make sure your hands are clean and
free of any lotions and oils prior to application. The
screen must be completely free of dirt, oil or dust
in order to successfully apply the tempered glass.
"Always There,Never Seen"
FULL SCREEN
Tempered Glass
Screen Protection
HD Clarity ❙ 9H Hardness
Shatter & Scratch Resistant
Smooth Glass Surface
0.33 mm Thickness ❙ Bubble-Free
• ProGlass Tempered Glass
• Multi-purpose Cleaning Wipe
• Microfiber Polishing Cloth
• Dust Removal Tape
• Easy Applicator
• Instructions
Package includes:
Peel/Pull Film Off of ProGlass.
Be careful not to touch the adhesive.
4-Step Quick Application
For best results, clean entire phone thoroughly prior to Step 1.
STEP 1 Applicator
STEP 2 Clean Phone
STEP 3 Peel Film
Once this 3-step cleaning process is complete, do
not touch the screen. Any dust or dirt/oil that is
left on the screen will show under the ProGlass.
Place Phone into Easy Applicator.
Clean the screen of your phone using the enclosed
ProGlass Cleaning Wipe.
Next, use the Microfiber Polishing Cloth and gently
wipe the screen.
For final cleaning step, use the Dust Removal Tape
to rid of any remaining dust particles.
STEP 4 Apply Glass
Align ProGlass using the Easy Applicator. Lay the
tempered glass flat on top of the screen, adhesive
side down.