U-Line H-2015 User manual

PAGE 1 OF 2 0516 IH-2015
πH-2015
INDUSTRIAL
ILLUMINATED MAGNIFIER
1-800-295-5510
uline.com
INSTALLATION
1. Locate and remove clamp from packaging.
2. Use the screw mechanism to open the clamp to the
thickness of desired mounting surface.
3. Slide clamp onto desired
mounting surface and
use screw mechanism to
tighten. (See Figure 1)
NOTE: Clamp
must be tightened
completely before
attaching lamp.
4. Remove lamp from
packaging.
CAUTION! Use both hands to hold lamp arm
closed when removing from packaging. Open
arm slowly and carefully.
5. Lower stem of lamp into
the hole in the clamp.
(See Figure 2)
6. Insert plug into properly
rated 120V outlet.
7. Adjust magnifier
head to desired
position and tighten
adjustment knobs to
secure the position on
each axis.
(See Figure 3)
8. Remove magnifier cover and toggle the switch to
activate the light.
NOTE: When not in use, replace magnifier
cover to prevent fire hazard.
REPLACEMENT BULB (H-2017 – SOLD SEPARATELY)
1. Turn off and unplug H-2015 before replacing the bulb.
2. Remove lamp from table clamp and lay on a clean,
flat surface with the underside of the magnifier head
facing up.
3. Use a Phillips head
screwdriver to remove
the four screws on
the underside of the
magnifier head.
(See Figure 4)
Figure 1
Figure 3
Figure 2
Figure 4

PAGE 2 OF 2 0516 IH-2015
INSTALLATION CONTINUED
4. Pull plastic tab away
from magnifier head to
remove the plastic light
covering. (See Figure 5)
5. Gently pull old bulb off
the 4 pin connector
and replace with a new
H-2017 replacement
bulb. (See Figure 6)
NOTE: Replace
only with H-2017
(sold separately).
Other bulbs may
do damage to the
lamp function of
the magnifier.
6. Replace plastic light covering by reversing steps 3
and 4. Reset lamp into clamp on work surface.
OPTIONAL LENS (H-2016 – SOLD SEPARATELY)
1. Fix the magnifier head in a position parallel to the
ground.
2. Gently pull the tabs on
the front of the magnifier
away from the lens and
upward to release the
lens retaining ring.
(See Figure 7)
3. Lift the lens out of the
magnifier head and
carefully store to avoid
damage. (See Figure 8)
4. Carefully lower optional
replacement lens into
magnifier head.
5. Replace lens retaining
ring.
Figure 5
Figure 6
Figure 7
Figure 8
πCHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com