UCP Expression Guide

ADJUSTMENT GUIDE
UCP Expression Chair
www.ucpwheels.org

TABLE OF CONTENTS
2
www.ucpwheels.org
Tools needed 3
Adjustment :
1. Footrest Height 4
2. Seat Depth 5
3. Back Tilt Angle 6
4. Back Height 7
5. Seat height 8
6. Caster 10
7. Center of Gravity 12
8. Brake 13
9. Tension back 14
10. Anti-Tip 15
11. Arm Rest 16

Tools needed
Phillips Screw Driver
2 Wrenches no. 13
Rubber Hammer
2 Wrenches no. 10
3
www.ucpwheels.org

1. Footrest Height
Adjustment
STEP 1
Loosen the nut (left and right).
Adjust according to user’s needs.
Note marks on tube.
4
www.ucpwheels.org

2. Seat Depth Adjustment
STEP 1
Loosen bolt #1 and remove bolt #2.
Lift and slide the back rest.
5
www.ucpwheels.org

3. Back Tilt Angle
Adjustment
STEP 1
Loosen & remove bolt and nut.
STEP 2
Adjust backrest angle to fit the
user’s need. Re-install bolts and
tighten all four nuts.
6
www.ucpwheels.org

4. Back Height
Adjustment
STEP 1
To change back height, first remove
tension adjustable back strap. Then
remove the bolts.
7
www.ucpwheels.org

5. Seat Height
Adjustment
8
www.ucpwheels.org
STEP 1
Seat height adjustment helps put the user’s arm
in the strongest pushing position, with elbow at 90
when hand is at top of hand rim.
To start, loosen all four bolts on axle bracket.
STEP 2
Tap the bracket with a rubber hammer to move the
bracket.
Note : When in correct position, tighten all four
bolts.
Be careful to position nut holder tight inside the
axle bracket.

5. Seat Height
Adjustment
9
www.ucpwheels.org
STEP 3
The caster barrel must be at 90 degrees or the chair
will be difficult to push and turn. Move the caster
axle to the same position 1, 2, or 3. To start, use a
13mm wrench to remove the axle.

7. Center of Gravity
Adjustment
10
www.ucpwheels.org
STEP 1
Remove rear wheels, loosen top bolts & bottom
bolts.
STEP 2
Move as needed.
Carefully tighten bolts. Nut holders must be
completely inserted.
STEP 3
Loosen nuts of fender holder. Adjust to the rear
wheel position.