www.goliathhardware.com.au
Step 3: Attaching the internal member
to drawer unit
Step 4: Attaching the external members
Step 5: Assemble drawer to cabinet
Install the internal member to the drawer member to
the center of the side panel of your drawer unit.
Make sure both of the internal slide members are
mounted vertically and horizontally parallel.
Use the vertical slots to fasten, this will allow you
some room for error when adjusting the internal slide
member.
The front end of the drawer slide should leave a
maximum 2mm gap to the drawer fascia
Align external unit to center of marked lines of where your
drawer unit will be.
Holding the slide rmly in place, push the inside extension
forward until screw holes are visible.
Using the screws provided, mount the slide to the inside
of the cabinet using the horizontal slots. Use as many
screws as you feel is necessary for the unit, with 3 screws
minimum
Repeat to mount the second drawer slide on the opposite
side of the cabinet.
With the internal member attached to drawer unit and
external member attached to cabinet unit, now it’s time to
place your drawer into the cabinet.
The drawer should slide in without issue. If the slide does
not t, unfasten screws slightly and adjust slide members
to correct position.
Once this is done, repeat starting from step 1 for all
remaining drawers.
