ULAX FURNITURE 730023 User manual

Umbrella Side Table
730023

A
B
C
D
E
F
G
H
I
K
J
TABLE TOP 1
TABLE LEG 2
SIDE PANEL 2
BOTTOM PANEL
1
UMBRELLA BASE POLE 1
PLASTIC UMBRELLA
RING
1
M0.24"*0.59"BOLT 8
M0.24"*0.79"BOLT 3
M0.24"*1.18"BOLT 8
WASHER 19
ALLEN WRENCH 1

Attach the umbrella base pole (E) to the bottom panel (D) by using
bolts (H) and washers (J). Hand tighten only.
Attach a side panel (C) to the table leg (B) by using bolts (I) and
washers (J). Hand tighten only.

Attach the table top (A) to the table legs (B) by using bolts (G) and
washers (J). Hand tighten only.
Attach the bottom panel (D) and umbrella base pole (E) to table leg (B)
and side panel (C) by using bolts (G) and washer (J). Hand tighten only.
PAGE 3 OF 5

STEP 5
Use the allen wrench (K) to tighten all bolts. Do not over tighten. Over
tightening may strip bolts. Place the table on the upright position and
put the plastic umbrella ring (F) on the umbrella hole.
F.
STEP 6
Now you have your new WICKER UMBRELLA SIDE TABLE.
WARNING: Umbrella may not withsand high winds. To avoid injury
or damage, do not use in high wind conditions. Always retract
umbrella when not in use.
PAGE 4 OF 5

rUmbrella Side Table,