Ultra electronics HyperSpike HS-10 User manual

J
HS‐10QuickReferenceGuide

UltraElectronics—USSI
4868EPark30Dr
ColumbiaCity,IN46725
Phone:260‐248‐3665
ServiceDepartment@ultra‐ussi.com

WARNING:
HIGHLEVELOFSOUNDCANBEEMITTED.
HEARINGPROTECTIONRECOMMENDED.
TEMPORARYORPERMANENTHEARING
DAMAGEMAYOCCUR.
K

WARNING:
THISPRODUCTCONTAINSLITHIUMION
BATTERIES.SEEOWNER’SMANUALFOR
HANDLINGANDSAFETYINSTRUCTIONS.


HS‐10QuickReferenceGuide

Forfullproductmanual,see
hp://www.ultra‐hyperspike.com/HS‐10.

OPERATION:
PressandholdthePowerBuon(E)foronesecond
toturntheHS‐10onandoff.

AlertTone:
1.Setvolumeknob(F)todesiredlevel
2.PressandholdAlertToneBuon(C)
Note:AlertTonehaspriorityoverlivevoice,record
playback,andlineinput.

Record/Playback:
1.Plugmicrophoneinto‘MicInput’(H)
2.SelectRecord/Playbackmodewithbuon(G)
3.Setvolumeknob(F)todesiredlevel
4.Pressandholdmicrophonekeyswitch(K)
5.Speakloudlyandclearlyintomicrophone
6.Releasemicrophonekeyswitch(K).Unitwill
automacallyplaybackrecordedmessage.
Note:Tostopplayback,pressandreleasemicro‐
phonekeyswitch(K)rapidly.

LiveVoiceMode:
1.Plugmicrophoneinto‘MicInput’(H)
2.SelectLiveVoicemodewithbuon(G)
3.Setvolumeknob(F)todesiredlevel
4.Pressandholdmicrophonekeyswitch(K)
5.Speakloudlyandclearlyintomicrophone
Note:IftheLiveVoiceaudiosqueals,chooseRecord/
Playbackmode,reducevolume,ormovemicro‐
phonefurtherawayfromtheunit.

ILLUSTRATIONLEGEND:
A.LEDStatusIndicator(Status/Charge/Fault)
B.LEDModeIndicator(Record/PlaybackorLive
Voicemode)
C.AlertToneBuon(triggersalerttone)
D.LineInput(lineinputconnectorforMP3
player/phone/etc.)
E.PowerBuon(turnsHS‐10onandoff)
F.VolumeKnob(adjustssystemvolume)
G.ModeBuon(cyclesmodebetweenRecord/
PlaybackandLiveVoice)
H.MicrophoneInput(microphoneinput
connector)
J.ChargePort(baerychargeconnector)
K.MicrophoneKeySwitch

ChargeInternalBaery:
1.PlugchargerintoChargePort(J)
Note:Unitwillnotfunconwhilechargeris
pluggedin.Removechargertoresumeoperaons.

LineInput:
1.Plugauxiliaryplayer(MP3/phone/etc.)into‘Line
Input’(D)
2.Setoutputvolumeofauxiliaryplayertohigh
3.Setvolumeknob(F)todesiredlevel
4.Pressplayonauxiliaryplayertobroadcast


STATUSINDICATORS:
WhentheHS‐10isiniallypoweredup,thestatus
indicators(A&B)willbrieflyturnonforsystem
inializaon.Refertochartforstatusindicator
codes.

StatusIndicator(A):
SolidGreen–Unitreadytooperatewithfull
baery
FlashingGreen–Unitreadytooperatewithlow
baery
SolidYellow–Chargerconnected‐Unitin
Standbymode‐Fullycharged
FlashingYellow–Chargerconnected‐Unitin
Standbymode‐Charging
SolidRed–Fault–Seemanualorcontact
authorizedservicefacility

ModeIndicator(B):
SolidGreen–UnitinRecord/Playbackmode
SolidRed–UnitinLiveVoicemode
90199A‐QRG‐HS10REVC
B
C
A
D E F G H