Ultradent GEMINI EVO 810 User manual

ADDENDUM ON ACTIVATION PEDAL
This document replaces content on the following pages
of your original User Manual:
6, 11, 13, 16 and 36

2
OVERVIEW - ACTIVATION PEDAL
LASER
ACTIVE
BATTERY
LEVEL
BLUETOOTH
CONNECTION
HAPTIC
FEEDBACK
60 to 100%
Icon turns
blue when
connected
Bluetooth
pairing
button
Activation Pedal will
not connect if battery
indication shows red
25 to 59%
0 to 24%
Laser Active turns green when pedal is pressed.
Haptic Sense “HS” indicator
Battery Indicator Bluetooth
Overstep/Shroud
Protection
Activation Area
Pedal Status Indicators Battery Compartment Lid
1x Rechargeable Li-Ion Battery
Label / Anti Skid Areas
LASER
ACTIVE
BATTERY
LEVEL
BLUETOOTH
CONNECTION
HAPTIC
FEEDBACK
Replaces page 11

3
Icon turns
blue when
connected
Label / Anti Skid Areas
20 - ADD NEW ACTIVATION PEDAL
OR RECONNECT / PAIR - BLUETOOTH CONNECTION
In certain instances, your oce may need to have an additional Activation Pedal with the same Gemini EVO device,
or you may lose your Bluetooth pairing connection. In either case, follow the instructions below to properly reconnect
and establish pairing Bluetooth connection with your Gemini EVO unit. For a successful pairing, the sequence
below must be followed:
PRESS THE
BLUETOOTH BUTTON PAIRING
LASER
ACTIVE
BATTERY
LEVEL
BLUETOOTH
CONNECTION
HAPTIC
FEEDBACK
“ Bluetooth Pairing Successful”
“ Bluetooth Pairing Enabled”
LASER
ACTIVE
BATTERY
LEVEL
BLUETOOTH
CONNECTION
HAPTIC
FEEDBACK
2
1
3
CONTROLS, OPERATION & USE
Icons will ash indicating Bluetooth pairing is enabled
Press and hold the HOME icon for 5 seconds.
Activation Pedal automatically connects to your Gemini EVO device.
Push
button 1x
to start
pairing
Replaces page 36

LASER
ACTIVE
BATTERY
LEVEL
Replaces an image from page 6 Replaces an image from pages 13 and 16
Activation Pedal + 1x rechargeable
Li-Ion Battery + micro USB Cable
Install the provided Li-Ion battery into
the wireless activation pedal
WHAT IS IN THE BOX QUICK START
CAUTION: Terminal can get
very hot during charging
WARNING:
Fast charger
is prohibited.
Charging Status
Charging
Charged
RECHARGEABLE LI-ION BATTERY - 18650
Your Gemini EVO activation pedal comes with a rechargeable Li-Ion battery. Use the supplied micro-USB cable to
fully charge the battery before use by connecting it to the USB port on any computer or by using an AC to USB wall
charger plug. The indicator near the battery charging port will be red when charging and blue when fully charged.
Note charging time will take 5-6 hours.
Manufactured by Azena Medical, LLC. 3021 Citrus Circle, Suite 180, Walnut Creek, CA 94598 USA. Made in the USA of U.S. and imported components.
Distributed by Ultradent Products Inc., 505 West Ultradent Drive, South Jordan, Utah 84095 1011432AR01 071522
800.552.5512 |ULTRADENT.COM