Uni-Com VAA-FMT1-TR User manual

Coaxial/Fiber Optic
Video Converter
Installation Guide
VAA-FMT1-TR
SPECIFICATIONS
Interface Transmitter: 1 x BNC (Female) / Input Signal
1 x ST for single / Output Signal
Receiver: 1 x BNC (Female) / Output Signal
1 x ST for single / Input Signal
Bandwidth: DC to 12 MHz
Impedance: 75 Ohm.
Input Signal Range: 1V<Vp-p<2.4V
Signal-to-Noise Ratio: ≥60dB
Output Signal Range: 480mV<Vp-p<1.1V
System Bandwidth: 8MHz
Transmission Loss: Max. 13dB
Power Supply: DC 9V 1Amp
Distance: Maximum length 2.5km
Cable Type: 62.5/125um Multi-Mode fiber cable
Wave Length: 850nm
Enclosure: Aluminum Case
Dimensions: 2.2” (W) x 4.15” (L) x 0.8” (H)
VAA-FMT1-TR Video/Fiber Optic Converter, ST/Multi-
Mode, Kit with Transmitter and Receiver
VAA-FMT1-T Video/Fiber Optic Converter, ST/Multi-
Mode, Transmitter
VAA-FMT1-R Video/Fiber Optic Converter, ST/Multi-
Mode, Receiver
ORDERING INFORMATION
©UNICOM 2003. UNICOM is a trademark of UNICOM Electric, Inc. All rights reser ed.
Specifications subject to change without notice.
908 Canada Court
City of Industry, CA 91748 U.S.A.
Phone: [phone] or 800.346.6668
Fax: [phone]
www.unicomlink.com
e-mail: [email protected]
Coax/fiber Vid Convert Manual 3/4/03 4:20 PM Page 1

UNICOM’s Video/Fiber converters are designed to convert
baseband video signal to Multi-Mode fiber optic. This converter
comes as a set with Transmitter and Receiver and must be used in
pairs. They easily extend your video signal up to 2,500 meters.
Linear modulation and wideband low noise circuit design assures
transmission quality to meet NTSC, PAL, SECAM and D2MAC
specification. To get maximum extension, just install new or use
your existing fiber optic cable for your next video extension.
Coaxial/Fiber Optic Video Converter
Recei er
Transmitter
BNC
Coaxial
Cable
Transmitter Receiver
BNC
Coaxial
Cable
62.5/125µm
Multi-Mode fiber
cable up to 2.5km
Input
VIDEO/AUDIO
ADAPTER
(Receiver)
Output
Output
VIDEO/AUDIO
ADAPTER
(Transceiver)
Input
APPLICATION DIAGRAM
Video Monitor
CCD/Camera
Coax/fiber Vid Convert Manual 3/4/03 4:20 PM Page 2