Unicare Health Emergency Bed Power Unit Instruction Manual
Emergency Bed Power Unit (EBPU)
Instruction & Safety Manual
Please read this manual before operation, for
maintenance instructions and safe usage
The enabling power
of applied knowledge
1
Emergency Bed Power Unit, Instruction & Safety Manual
T08 9351 7500 E[email protected] Wwww.unicarehealth.com.au
Installation & Operation
Upon receipt of the EBPU, inspect the shipping carton for damage. If there is any obvious damage
please report it immediately to your supplier. If there is no damage to the shipping carton, unpack the
unit, inspect the unit for damage.
The EBPU is designed for installation in a protected environment with a temperature range of 0-40°C
and relative humidity of 0-90% without condensation. Do not block inlets or outlets. Install the system in
a location free from excessive dust and chemical fumes. Check the identifi cation label to verify that the
EBPU voltage and power rating match the available line voltage and load requirements.
2
T08 9351 7500 E[email protected] Wwww.unicarehealth.com.au
Troubleshooting with EBPU Indicators:
Yellow
LED
Green
LED
Red
LED BUZZER UPS STATUS
ON OFF OFF OFF Mains normal, charging battery
ON OFF OFF Mains normal, UPS in normal mode
OFF OFF FLASHING EVERY 5. SEC Mains fail, running on battery
OFF OFF FLASHING TWICE PER SEC Low battery, prepare to switch off
OFF OFF SOLID TWICE PER SEC Overload, remove load
OFF OFF SOLID CONTINUOUS UPS faulty, switch unit off
OFF OFF OFF OFF UPS battery discharger, sleep mode
FOR FURTHER TECHNICAL SUPPORT
PLEASE CONTACT
THE UNICARE HEALTH TEAM ON:
08 9351 7500
www.unicarehealth.com.au
3
Emergency Bed Power Unit, Instruction & Safety Manual
T08 9351 7500 E[email protected] Wwww.unicarehealth.com.au
Specifi cations
Ratings:
Voltage Amperes (VA) 600 1000 1400
Input:
Rated AC Input Voltage 230V±25%
AC Input Voltage Window 165-275V
Input Frequency 40-70Hz
Output:
AC Output Voltage (Typical) 230V
AC Output Voltage Tolerance Nominal ±10%
Output Frequency 50Hz
Output Frequency Stability <0.5Hz (Battery Mode)
Output Waveform Step Sine Wave 0.6
4
T08 9351 7500 E[email protected] Wwww.unicarehealth.com.au
Installation
1. Connect the power cord to a verifi ed grounded 3-wire receptacle.
2. Turn on the power switch of EBPU, the green and yellow LED will be lit indicating AC utility voltage
is present.
3. Charge the batteries for 10hours before use. You may use the EBPU immediately without recharging,
but the backup time may be less than the rating.
4. Connect your computer to the output receptacles of the UPS.
5. To Test backup function, you may disconnect the power cord of the EBPU from wall outlets. The red
LED will fl ash, and buzzer will beep every 5 seconds.
6. When the battery approaches low level, buzzer will beep twice per second until unit shuts down.
7. 4 conditions that cause the EBPU to shut down automatically:
• Battery Low
• Short Circuit
• Overload
• EBPU Fault
Caution
• The EBPU contains voltage that is potentially hazardous. All repairs should be performed by
qualifi ed service personnel.
• The EBPU has its own internal energy source (battery). The output receptacles may be alive when
the EBPU is not connected to an AC supply.
• The EBPU is designed for electronic supply for applications such as electronic patient equipment
and hospital beds containing a substantial rectifi er or capacitive load. It is not suitable for signifi cant
inductive loads.
• Be sure to operate within the power rating of the EBPU. Below 1/2 or 1/3 of the rated power is
recommended for longer backup time and battery life.
• Do not place the EBPU near excessive humidity, direct sunshine, or close to heat-emitting sources.
If the EBPU is out of order, detach power cord and consult your supplier right away. Do not remove
the cover, there are no serviceable parts inside.
• The unit should be supplied by a grounded source. Do not operate the unit without a ground source.
• Do not plug the EBPU’s power cord into itself. That will result in a safety hazard.
5
Emergency Bed Power Unit, Instruction & Safety Manual
T08 9351 7500 E[email protected] Wwww.unicarehealth.com.au
Specifi cations
Batteries
Nominal Voltage (VOC) 12 12 12
No. x Capacity (Ah) 1x7 2x7 2x7
Type 12V SLA
Service Life 3-5 years (depending on use)
Battery Recharge 90% 8 hours
Autonomy >6minutes load dependent
General
Net/Gross Weight (kg) 6 10.9 12.1
Dimensions (LxWxH) 95x312x158 124x372x223 124x372x223
Enclosure/Protection Steel-plastic/IP 20
Environment
Safety EN 50091-1-1
Electromagnetic Compatibility EN 50091-2, C-TICK, A-TICK
Ambient Temperature 0 to +40°C
Sound at 1metre <40dB
Max. Relative Humidity 95% (non-sondensing)
PO Box 82 Bentley WA 6982
T 08 9351 7500 F 08 9350 5299
www.unicarehealth.com.au
Authorised Distributor
This manual suits for next models
1
Table of contents
Other Unicare Health Personal Care Product manuals
