Union Home DANIEL BDM00137 User manual

Thank you for purchasing the Daniel Dresser. Before you begin to assemble your new piece ourniture, please
check to ensure that all hardware and parts have been supplied. This page lists all contents included
in the carton(s). Follow instructions closely as deviation from them may present a possible safety risk and may void
your warranty.
It is recommended that assembly is done on a soft surface such as carpet to avoid any damage.
Page 1of 4
Parts:
Y X 1
DANIEL DRESSER
BDM00137/BDM00150
Hardware | Anti Tip Kit (Supplied)
Care Information
Dust weekly using a soft, clean cloth. Do not use harsh abrasives, chemicals or polishes containing
Silicone to as they can damage this nish.
Avoid direct sunlight as this will cause the timber to change colour. It is important to remove moist
substances immediately.
Note: Thank you for the purchasing Daniel Dresser. While great care is taken during production.
This piece may have some subtle natural splitting, cracking or chipping that give a natural vintage look. Such a look is
part of the charm and appeal of this crafted timber product and not a manufacturing defect.
A X 2 B X 2 C X 4 D X 4 E X 2 F X 2 G X 1
4MMM6X30
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF UNION HOME.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized reproduction,
adaptation, distribution or other infringement will be prosecuted.

Step 1:
Step 2:
Page 2 of 4
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF UNION HOME.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized reproduction,
adaptation, distribution or other infringement will be prosecuted.
DANIEL DRESSER
BDM00137/BDM00150

Step 3:
Page 3 of 4
Fixed
With
Wall
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF UNION HOME.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized reproduction,
adaptation, distribution or other infringement will be prosecuted.
Anti Tip Kit Installation
1) Using screws provided and a screwdriver, secure mounting plate(s) to the back of product.
2) Noting the location of the product's mounting plate(s), mark and drill holes on the wall for mounting plate(s). Drill
pilot holes into marked positions and into a wall stud. NOTE: if wall studs are not available, drill holes slightly smaller
than the drywall anchors and insert each anchor until its ange is ush with the wall.
3) Using a screwdriver, secure mounting bracket(s) to the wall stud or drywall anchors with screws provided.
4) Position product in nal location, and secure to the wall by lacing one end of plastic tie(s) through both the wall
and product mounting plates, and through the other end, pulling tightly to remove slack. Do not over tighten.
DANIEL DRESSER
BDM00137/BDM00150

Step 4:
Page 4 of 4
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF UNION HOME.
All rights reserved, including all applicable copyright, design and patent rights. Any unauthorized reproduction,
adaptation, distribution or other infringement will be prosecuted.
DANIEL DRESSER
BDM00137/BDM00150