Unior 1693EL.20 User manual

Remote control set
Set za daljinsko upravljanje
Unior d.d.
Kovaška cesta 10
3214 Zreče, Slovenia
T: [phone]
[e-mail]
www.uniortools.com
1693EL.20
uniortools.com
EN
SLO
909682801
Testing the Remote Controller system
• Plug-in the power cord and turn-on the key
• Press and hold the button Up on remote controller for about 2 seconds.
The stand should start to move upwards and should stop after releasing
the button Up.
• Short press and release of button Up. The stand should start to move
upwards until the press of button Stop on remote controller before it
reaches upper limit position.
• Repeat the same procedure for button Down and Stop on remote
controller.

Unscrew and pull out the controller module - remove four screws at the bottom of enclosure (no need to disconnect
cables from controller, it can be left out of enclosure by hanging on the cables).
Turn-off the power key and
disconnect power cord
Install remote receiver into the socket connector on the bottom of controller. Caution! Remote receiver is electrostatic
sensitive device. Avoid touching the contacts of Receiver before it is installed into the socket. Install receiver precisely
to predefined location, marked with white rectangle on the controller.
Plug-in the antenna connector into the controller.
Attach the antenna into the antenna holder.
Receiving signal from remote controller depends of antenna position so the self-adhesive holder must be attached as
presentend on image.
Install the controller back into the enclosure and fix it with four screws.
Close the enclosure rear cover and attach it with screws.