Unitech WD200 User manual

How to Attach WD200 Wrist Holder Kit
Installation Guide
Version 1.0

Introduction
The Wrist Holder Kit (PN#3210-900026G) consists of three parts,
Wrist Bracket (PN#608941G), Wrist Holder pad (PN#386215G) and Wrist Holder strap (PN#609032G).
Please install the wrist holder kit following the instructions below.
Wrist Holder Kit
(PN#3210-900026G)
Wrist Bracket
(PN#608941G)
Wrist Holder pad
(PN#386215G)
Wrist Holder strap
(PN#609032G)

Install WD200 to the wrist bracket
(1) Flip WD200 to its rear side, and the power button side facing left.
(2) Flip the bracket to ensure the Velcro side is facing upward.
(3) Slide WD200 into the two recesses on the bracket. You will hear a click sound when attached successfully.

Slip the wrist holder strap through the wrist bracket
(1) When holding the strap, make sure the arrows on the back are pointing to the direction of the bracket.
(2) Make sure the Velcro side of the strap is facing upward.
(3) Thread the strap through the slot connection.
Rear view of the strap

Put the wrist holder pad onto the bracket
(1) Put your hand between the strap and the bracket to make a space.
(2) Attach the pad on the bracket.
Note: make sure the Velcro side of the pad is facing down and matches with the bracket.