STEP2 Point the remote at the component and press and hold the [DEVICE] key for 3 seconds until the Device LED blinks
off and turns back on. Continue holding the [DEVICE] key and press the numberkeys, one at a time, starting with 1,
then2, 3...0. Stop pressing the number keys when the device turns off.
STEP3 Release the [DEVICE] key to save the code. The Device LED will blink twice to confirm the code is stored.
Repeat the steps above for all components(STB, TV).
B.
B. Manual Programming
Manual Programming
The remote controlcan beprogrammed by entering a three!digit code number that corresponds to particular brands and
models of equipment. The three!digit code numbers are listed in the code tables sections of this instruction manual.
STEP1 Turn on the equipment that you want the remote con!trol to operate (Set Top Box or TV).
STEP2 Press the [DEVICE] button and the [OK/SEL] button simultaneously for 3 seconds. The corresponding device LED
will turn on indicating that it is ready to be pro!grammed. The LED will remain on for 30 seconds. The next step
must be entered while the LED is on.
STEP3 Point the remote control toward the equipment and enter the three!digit code number assigned to your brand
from the code tables. If there are more than one three!digit number listed for your brand, try one code
number at a time until your equipment turns off.
*Note: You can verify that you have selected the correct code by pressing the [POWER] button. The equipment should turn
back on. Then try all of the functions on the remote control (i.e. volume, mute, etc.) to ensure you have the
correct code. If any of the functions do not operate as they should, repeat the instructions from STEP 3 above
using the next three digit code number from the brand list.
STEP4 Store the three!digit code by pressing the same [DEVICE] button once again. The device LED will blink twice to
confirm that the code has been stored.
C. Auto Search Method
C. Auto Search Method
If none of the three digit code numbers assigned to your brand of equipment works, or the code table does not list your
brand, you can use the Auto Search Method to find the correct three!digit code number for your equipment by
following steps:
STEP1 Turn on the equipment that you want the remote control to operate (Set Top Box or TV).
STEP2 Press the [DEVICE] button and the [OK/SEL] button simultaneously for 3 seconds. The device LED will turn on
indicating that it is ready to be programmed. The LED will remain on for 30 seconds. The next step must be enter!
ed while the LED is on.
STEP3 Press the [CH5] or [CH6] button one at a time or keep it pressed. The remote will emit a series of Power
ON/OFFcodesignals. Release the [CH5] or [CH6] button as soon as the equipment turns off.
*Note: You can verify that you have selected the correct code by pressing the [POWER] button. The equipment should
turn back on. Then try all of the functions on the remote control (i.e. volume, mute, etc.) to ensure you have the
correct code. If any of the functions do not operate as they should, repeat the instructions from STEP 3 above to
continue the Auto Search Method.
STEP4 Press the same [DEVICE] button to store the code. The Device LED will blink twice to confirm that the code has
been stored.
D.
D. Programming the All Off Button
Programming the All Off Button
This allows you to program the All Off button so it can send up to two power On/Off commands with one button press.
STEP1 Press the [STB] button.
STEP2 Press the [All OFF] button and the [OK/SEL] button simultaneously for 3 seconds. The [STB] button will turn on
for 30 seconds.
STEP3 Press the first [Device] button you want to store in the [ALL OFF] button and then the [POWER] button. Repeat
