Universal EXPLORE HOME 956A320 User manual

Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts
that may have come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and heavy. This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessively wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material.
The manufacturer will not be held responsible if preventative steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring.
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times.
INSTRUCTION SHEET
PARTS LIST:
# Description QTY #
A
C
E
B
D
QTY
Assembly Procedure: (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Assembly is now Complete
Description
Headboard
Footboard
Slat Support
Side Rails
Slats
1PC
1PC
6PCS
2PCS
3PCS
956A320
956A32FR Uptown King Bed
Page 1 of 2
Step 2: Screw side rails B to the headboard A and footboard C by wrench, make sure to screw it
tightly.
Step 3: Screw slat support E to the slat D, make sure to screw it tightly.
Step 4: Screw slats D to the side rails B, make sure to screw it tightly.
66

INSTRUCTION SHEET
HARDWARE LIST(F) Q'TY
1Ø5/16"*3" 8PCS
28PCS
Lock Washer3
4
8PCS
8PCSNut
51PCWrench 12mm
66PCS
Wood Screw #8*1''
Head Bolt
Half Round Washer
1
2
3
4
5
Page 2 of 2
Uptown King Bed
Ø5/16"*12*3
Ø5/16"*12
L32*13*8
956A320
956A32FR