Universal Explore Home 827-690 User manual

INSTRUCTION SHEET
827-690 Bar Cabinet
Thank you for purchasing this quality product Be sure to check all packing material carefully for small
parts that may have come loose inside the carton during shipment
Caution: (1) These parts are cumbersome and heavy This product can best be assembled with the
assistance of one or more persons in order to prevent personal injury and to insure parts are not damaged
during the assembly process If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth Cloth should not be excessively wet Polish finish with soft cloth and an industry
recognized furniture polish
(2) To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after removing the packaging material
The manufacturer will not be held responsible if preventative steps are not taken prior to installation
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware Read the instruction sheet and parts list carefully Remove all staples and screws used for
packaging carefully using pliers and or screwdrivers to prevent injury and scratching or damaging flooring
(4) During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up They should be
periodically inspected and re-tightened to prevent damage to the furniture and (or) personal property or cause
injury Always check to be sure all hardware on this list and the above mentioned components is attached to
the furniture properly and kept tightened at all times
PARTS LIST:
#
Description
Qty.
#
D
escription
Qty.
A
Cabinet 1pc Leg 4pcs
C
Shelf 1pc
D
Divider 8pcs
E
Magic Wire 16pcs
F
Hardware pack 1bag
Assembly Procedure : (Please follow the sketches below )
Step 1: Unpack, inspect, and read assembly instruction carefully Lay out the parts and hardware
Make sure the quantity of each is correct
Step 2: put the cabinet (A) upright down on a soft and smooth surface to avoid damage or being
scratched Attached the legs (B) to the bottom of cabinet (A) with nuts (2), spring washers (3)
and flat washers (4) using wrench (1) Tighten all the bolts and turn it upright
Step 3: screw the adjustable shelf (C) to the cabinet with shelf pins (5) and wood screw (6) using
screwdriver (not provided) Then attach the divier (D) to the inside of box with magic wire (E)
as below shown
Note : It is best for two or more persons are involved
Assembly is now complete.
23
4
HARDWARE LIST(F)
1
Q'TY
2
1PC
4PCS
5/16"
5/16"
3
4
5
6
5/16"*19mm
#6*5/8"
4PCS
4PCS
4PCS
5/16"
4PCS
WRENCH
NUT
SPRING WASHER
FLAT WASHER
SHELF PIN
WOOD SCREW
Step 2
AB

INSTRUCTION SHEET
827-690 Bar Cabinet
5
6
C
D
Step 3
E