Universal Explore Home 827-802 User manual

INSTRUCTION SHEET
827-802 End Table
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small
parts that may ha e come loose inside the carton during shipment.
Caution: (1) These parts are cumbersome and hea y. This product can best be assembled with the
assistance of one or more persons in order to pre ent personal injury and to insure parts are not damaged
during the assembly process. If dirty, clean finished parts with mild dishwashing liquid and water solution
applied on damp cloth. Cloth should not be excessi ely wet. Polish finish with soft cloth and an industry
recognized furniture polish.
(2) To pre ent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residue and rough surfaces and also check for staples or nails left after remo ing the packaging material.
The manufacturer will not be held responsible if pre entati e steps are not taken prior to installation.
(3) Unpack and dispose of all packing material but be careful not to throw away any assembly parts or
hardware. Read the instruction sheet and parts list carefully. Remo e all staples and screws used for
packaging carefully using pliers and or screwdri ers to pre ent injury and scratching or damaging flooring.
(4) During normal use e eryday, screws, bolts, nuts and wooden plugs may loosen up. They should be
periodically inspected and re-tightened to pre ent damage to the furniture and (or) personal property or cause
injury. Always check to be sure all hardware on this list and the abo e mentioned components is attached to
the furniture properly and kept tightened at all times.
PARTS LIST:
#
Description
Qty.
#
D
escription
Qty.
A
Table Base 1pc Glass Top 1pc
C
Hardware Pack 1pc
Assembly Procedure : (Please follow the sketches below.)
Step 1: Unpack, inspect, and read assembly instruction carefully. Lay out the parts and hardware.
Make sure the quantity of each is correct.
Step 2: Put all the parts on a soft and smooth surface to a oid damage or being scratched. Then put
the glass top (B) onto the table base (A) with plastic disc (1).
Assembly is now complete.
HARDWARE LIST(C)
1
Q'TY
4PCS
∮ 10*H1.5mm
PLASTIC DISC
A
B
1
1
1
1

INSTRUCTION SHEET
827-802 End Table