UNLEAZHED UNSCRATCH BP01 User manual

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Assembly instructions for our bike protection UNSCRATCH BP01

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
top tube down tube E-frame rear triangledown tube

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Remove rough dirt and then clean your bike with a commercially available "cleaning product | surface cleaner".
Important: your bike must be free of oil and grease.
Ablösen der Shapes vom Bogen

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Apply at room temperature between 20 °C and 22 °C.
Shapes can be applied according to our application plan (pages 6-9), but also according to your own ideas.
The foil should extend at least 1 cm beyond the edges of your frame to achieve the desired adhesive strength.

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
After gluing, the individual shapes should be treated with a household hairdryer on level 3.
For optimum adhesion: Leave your bike in the garage for another 24 hours!

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Bounding plan | top tube
1
2
3-10

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Bounding plan | down tube
1
2
3- 5
6- 9

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Bounding plan | down tube | E-frame
1
2
3
4- 7

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
4-5
1- 2
6
3
Bounding plan | rear triangle

unleazhed GmbH | Zur Messe 9a in 01067 Dresden | www.unleazhed.com/support/downloads/ | [e-mail]
Our tips:
•The surface cleaner must be suitable for use on your bike.
•If there are already scratches on your bike, close them before applying the film.
•It is possible to use a high-pressure cleaner, but please keep it at a distance of 30 cm from your bike when cleaning.