Uplift Desk UDA100-RISER User manual

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Step 1
Compare the parts you have with the list above. Place the
Main unit upside down on a table.
Attach the Keyboard tray using two M6x10 bolts, and tighten
using the smaller Allen wrench, as shown to the left.
Use the self-adhesive Bolt covers to cover the bolts.
Step 2
With two people, lift and ip the Main assembly and place it on
the table
Adjust the height of the unit by squeezing the release paddle
and moving to the desired position. Release the paddle to lock
in place.
Main unit Keyboard Tray M6x10 bolts
(qty 2)
Allen wrench
(large)
Allen wrench
(small)
Bolt covers
(qty 6)
Package Contents
Riser Standing Desk Converter
UDA100-RISER
Step 3 (Optional)
This step is optional. We have pre-adjusted the tension for
you. However, you may need to make adjustments once
equipment, such as monitors and keyboards, are placed on
the unit.
To adjust the lift to the exact amount of weight you place on
it; squeeze the paddle then lower the unit until the main sup-
port column is at a 45° angle. Using the larger Allen wrench
and the tension adjustment bolt on the rear of the unit, adjust
the tension for smooth operation. Turn clockwise to lessen
the tension or counterclockwise to increase it.
45°

© UPLIFT Desk • 800-349-3839 • [email protected] • upliftdesk.com
Step 4 (Optional)
If you prefer to use your UPLIFT Desk Riser Standing Con-
verter without a wrist rest, remove the bolts beneath it using
the smaller Allen wrench.
Copyright Notice: These instructions are a component of this product. These instructions are part of the scope of delivery, even if the item is resold. These instructions are also available on the UPLIFT Desk website: uplift-
desk.com. Excerpts or copies may not be forwarded to third parties or used in any other published form without the prior written consent of UPLIFT Desk. These instructions are subject to United States copyright law.
©
CAUTION: Read all instructions before assembly. Failure to assemble or operate properly may
result in damage or personal injury. Retain manual for future reference.
CAUTION: Make sure that the wires for your devices have enough slack. This will prevent your de-
vices from being pulled off the unit workstation when raising the unit.
CAUTION: Do not position the keyboard tray to hang over the edge of your desktop when in
the lowest position. The keyboard tray is designed to rest ON the desktop to prevent tipping.
CAUTION: The maximum load capacity of the UPLIFT Desk Riser Standing Converter is 28.6 lb
Do not overload.
CAUTION: When relocating the unit, remove all devices to avoid harm or damage,
and adjust the unit to its lowest position.
CAUTION: Keep hands clear during operation! Do not reach into the mechanism near
the gas spring, or near the supporting bars.
CAUTION: Keep devices centered and away from the edge of the main worksurface,
to prevent them from falling.
CAUTION: When moving, move it carefully with two people, to avoid injury and damage to the
product and surroundings.
CAUTIONS & WARNINGS
!
!
!
!
!
!
!
!
!
AI-UDA100-RISER-2.1