Uplift Desk ACC303 User manual

© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
®
View™Laptop Holder Instructions
ACC303
Part 1
View™ Laptop Holder
Part 2
Side brace
(qty 2)
Part 3
Brace clamp
(qty 2)
Part 4
M4x12mm screw
(qty 2)
Step 1
Attach the side braces to the View™ Laptop Holder (part 1) , place the side
brace (part 2) under the tray, as shown in g. 1; and afx the brace clamp
(part 3) through the opening and snap it into the Side Brace. This will hold
the side brace in place so it can move up and down.
Flip the latch on the back of the side-brace to extend their widths.
Fig. 1 Fig. 2 Fig. 3 Fig. 4
Step 2
To attach the tray at a more level angle, slide the upper set of pegs
onto the VESA plate’s open holes. Use the two M4x12mm screws (part 4)
and hand-tighten.
Package Contents:

© UPLIFT Desk • 1-800-349-3839 • [email protected] • www.upliftdesk.com
Step 3
To instead attach the tray at a steeper angle, rotate the monitor arm
Vesa plate 180 degrees, and use the lower set of pegs and holes on the
tray. Use the two M4x12mm screws (part 4) and hand-tighten.
CAUTION
!
10.1’’~17.3’’
Copyright Notice: These instructions are a component of the UPLIFT View ™ Laptop Holder . These instructions are part of the scope of delivery, even if the item is
resold. These instructions are also available on the UPLIFT Desk website: upliftdesk.com. Excerpts or copies may not be forwarded to third parties or used in any other
published form without the prior written consent of UPLIFT Desk.
These instructions are subject to United States copyright law.
©
•
•
•
•
The laptop sizes that best t on the
View Laptop Holder™ is 10.1’’~17.3’’
NOT A CHILD’S TOY. Children under 12 must be
supervised by an adult while using UPLIFT Adapt
View.
Failing to follow these assembly instructions
and safety precautions may result in personal injury.
Failing to follow these assembly instructions
and safety precautions voids your warranty
and may result in property damage.
®
Adapt™ View Laptop Holder
by