g. 1 g. 2
g. 3
Step 15
A.
The sockets slide freely along the Bar; we advise
sliding the outer sockets to each end of the bar to
allow more room when attaching the monitors. In-
sert each monitor’s VESA attachment into the sock-
ets on the Bar, starting with the middle monitor.
B.
For the center socket, use the 6mm Allen Wrench
to adjust the height. Turn clockwise to raise the
monitor and counterclockwise to lower it (g 1).
C. For the outside sockets,
turning the Screw on the
bottom provides up to 5mm of height adjustment
to help align the monitors. Turn the Screw either
direction with a Phillips head screw driver to set
the height. (g. 2)
D. Next, tighten the Screw on the side of each socket
to lock the monitors in place. (g. 3 & 4).
E.
Pull up slightly on each monitor to make sure each
are locked securely in place
.
F.
Once the monitors are locked in the sockets, slide
them inward to position them as desired. We rec-
ommend they meet in the center of the bar.
Step 17
A. Move the monitor assembly to any position and
release it. If the monitor assembly does not drift up
or down, the Arm is properly counterbalanced.
B. If the monitor assembly does not remain where
you positioned it, you will need to adjust the ten-
sion of the gas spring to properly support the
weight of your monitor assembly.
• If the monitor assembly drifts down when you
let it go, hold the Arm in a horizontal position as
shown and use the 6mm Allen Wrench to turn
the adjustment screw toward the “+” until it re-
mains in place when you let go.
• If the monitor assembly drifts upward when
you let go, turn the adjustment screw towards
the “-” until it remains in place when you let go.
Step 16
A. Attach the Handle to the Bar, you have four op-
tions. Choose between the two sets of holes on
the Handle and two sets of holes in the Bar to de-
termine which combination is best for you and al-
lows the bottom of the Handle to clear the bottom
of your monitors.
B.
When installing the Handle, you may need to
squeeze the ends together or pull them apart
slightly in order to align the holes in the Handle
with the holes in the Bar.
C. Connect the Handle to the Bar using the two
M6x22 screws and the 4mm Allen wrench.
g. 4
