Urbanista SYDNEY User manual

SYDNEY
(MANUAL)

LED

4
SYDNEY MANUAL (SINGLE SPEAKER) (ENG)
BUTTON CONTROLS
TURN ON/OFF - Hold for 3 seconds.
PLAY/PAUSE MUSIC - Press once.
VOLUME INCREASE - Press once.
VOLUME DECREASE - Press once.
PREVIOUS TRACK - Hold for 1 second.
NEXT TRACK - Hold for 1 second.
ANSWER/END A CALL - Press once.
REFUSE A CALL - Hold for 1 second.
USE SIRI - Press twice.
CONNECT TO DEVICE
Turn on the speaker via button
and then turn on the Bluetooth on
your device. Select “Urbanista Syd-
ney”. Upon successful pairing, the
LED breathes white every 10 sec.
If the speaker have been connected
to a device before, it will automatical-
ly go into pairing mode and connect
to the device when powered on.
RESET PAIRING
Press to disconnect the current
device and search for a new device.
Press again to reconnect to the
previous device.

5
SYDNEY MANUAL (TWO SPEAKERS) (ENG)
PAIRING 2 SPEAKERS
Turn on the speakers without being
paired to any device.
Hold the on both speakers for
1 second until the LED indicators ash
red and white. Upon successful pairing,
you will hear a “bip” sound.
LED on main speaker will ash white,
and the second speaker will ash white
every 10 second.
DISCONNECT 2 SPEAKER MODE
Press twice on either speaker. The
main speaker will keep playing and the
second will go into pairing mode.
CONNECT TO DEVICE
When the speakers are ready to be
connected to a device, turn on the
Bluetooth in your device and choose
“Urbanista Sydney”. Upon successful
connection, both speakers LED lights
will ash white every 10 seconds.
Main speaker will act as left channel
and the second speaker will act as right
channel.
DISCONNECT DEVICE
Press on the main speaker to discon-
nect the current and search for a new
one. Press again to reconnect to the
same device.