UTEPO USP201PVD24 User manual

The product is a video, control signal and power surge protector device designed
according to the standard of GB/T18802.21-2004/IEC61643-21:200. The device
features multi-level protection、high capacity for through-flow、low limiting voltage、
quick reaction time、less insertion loss. It adapts to overvoltage protection for security
video signal and power, protecting the device from the damage of induced overvoltage,
switching overvoltage and static discharge. It’s widely used in security monitoring
system, environment monitoring system.
Surge Protector
Please check the following item before installation. If it's missing, please contact the
dealer
Surge Protector 1set
User Manual 1set
Installation Steps
1) Before inserting the protector into the system, please make sure the grounding grid
reach the specification;
2) please make sure the connection is stable;
3) Please make sure the grounding cable of the surge protector is as short as possible.
Installation Steps
Board Diagram
Power,Video and Data Surge Protector
Application
Notice：
1) Please make sure the connection is correct, otherwise it will cause the damage of the
surge protector.
2) Please make sure to check the plug if the consumption is increasing. you can re-
connect it or replace the surge protector
3) Please don't unpack the component personally.
Power,Video and Data 3 in 1 Surge Protector
Grounding
Coaxial Cable Control Keyboard
Power Cable
UTP Cable
PTZ
Features
Standard: GB/T18802.21-2004/IEC61643-21:2000;
Protection: Baseband composite video signal(Bandwidth more than 10MHz)、12~24 AC
DC power;
Features: Multifunction multilevel overvoltage protection, large max discharge current,
low limiting voltage, quick reacting time, low insertion loss;
Grounding Mode: Extension Line to ground;
Design: Clear Logo, recognizable, aluminum shell, delicate size, easy installation;
12
Power
Surge Protector
Monitor
Notice
Please make sure the connection direction is correct.
Data Input
Video Input Video Output
Data output
Power Input Power output
Power LED
PE

Surge Protector
Specification
Specification Change will not be noticed
34
Surge Protector
Item
Description
Video and
control data
Working voltage(Un)
12V
Nominal discharge current(In)
3KA
Maximum discharge current(Imax)
5KA
Protection level(Up)
≤40V
Rate
Video:30Mbps data:10Mbps
Response time
1ns
Insertion loss
≤0.5dB
Connector
BNC male and Green terminal
Rated load current
DC500mA
Power
Working voltage(Un)
24V
Nominal discharge current(In)
5KA
Maximum discharge current(Imax)
10KA
Protection level (Up)
100V
Response time
25ns
Environmental
Working temperature
-40℃～85℃
Storage temperature
-40℃～75℃
Humidity (non-condensing)
0~95%
Mechanical
Weight
100g
Dimension (L×W×H)
100mm×60mm×38mm
Outer shell
Aluminum
Problem Examination
Inspect surge protector
Using multimeter “Ω” measuring input and output wire line resistance is 0Ω;If ,resistance value is
too much ,please replace for a new one.
Using multimeter “ Ω ” measuring wire line resistance to ground wire(yellow green cable), over
400kΩ. If it resistance value is too low, such as 0Ω, please replace for a new one.