Video Surge Protector
User Manual
The video surge protector meets the provisions of national standard IEC61643-
21:2000,protecting the equipment from damage due to monitor system signals induced
overvoltage, operating overvoltage and electrostatic discharge .It features multilevel protection、
large flow capacity、low voltage limited、quickly response and low insertion loss.
Features
2
1
Please check the following accessories before installation, if you find out the item miss,
please contact your local dealer
Single Channel video surge protector 1PCS
User Manual 1PCS
Installation steps
1) Check if the grounding resistance meets the specification before connect the device to
system.
2) Connect the protector to the remote device and make sure it’s connected reliably.
3) Connect the device ground wire to protection groud strap keeping in the shortest
possible distance. ground wire should be as shortest as possible.
Installation steps
Panel diagram
Note:
1) Make sure the connection of the plug IN, plug Out, output device and protected device
assembly following the instruction. Otherwise it will cause the damage to the protected
device.
2) If the loss increase is caused by the function of the plug, please replace it.
3) Any dismantle of the component by the user is not allowed. Inappropriate dismantle will
cause the damage to the protector.
Application
Video Surge Protector
CCTV camera
Monitor
Coaxial
Grounding
Surge Protector
Output
Grounding
Input
Grounding
Grounding
Multi-Level protection;
Large flow capacity;
Low voltage limited;
Quickly response;
Low Insertion loss;
V1
Surge Protector
