Uttermost REVELATION R25203 User manual

ATree Frame C Screws
B Marble Top
3.Softly clean & wipe with dry cloth.
1.Take the parts carefully out of the carton, and place them on a
flat and soft surface, making sure that the parts will not be damaged.
2. Place (B) marble top on base's top shelf, match all screw holes. Screw 8 screws in screw holes
(as photos) and don't tighten them first. After all screws are screwed in holes, then tighten them
by screwdriver.
Item :R25203
Parts/Hardware list
1 PC 8 PCS
1 PC

1.To avoid table tipping over, please read all instructions carefully and
completely before beginning use.
Part and hardware list
ABC
2PCS 2PCS 2PCS
Anti- tipping Instructions
1. Use a pencil to mark desired location for screw on wall. The location
must be lower than the height of table, and close two corners of base's
top shelf. Locate the metal bracket (A) on the wall and attach it through
the smaller hole to the wall using 2" screw ( B ) provided in plastic bag.
Use short screw to assemble smaller metal bracket on plywood back on
the back of marble top.
2.Place table near wall. Then lace the end of plastic strap ( C ) through
the large hole of the metal bracket pre-mounted on the wall and hole of
the small bracket under marble top. Tie them together securely.
2. Save all packing materials until etegare is secured on wall to avoid
accidentally discarding any parts or hardware.
Pencil-one pc,tape measure-one pc,
screw driver pc,
Item :R25203
Tool needed but not supplied
Metal
Bracket Screw Plastic Strap