V-Sol V2802W User manual

G/EPON 1GE+1FE+WiFi+CATV ONU Introduction V1.1
1 Access the world
Introduction
1.1 Product Description
G/EPON 1GE+1FE+WiFi+CATV ONU meets telecom operators FTTO (office), FTTD
(Desk) ,FTTH(Home) broadband speed, SOHO broadband access, video surveillance and
other requirements to design an EPON/GPON Gigabit Ethernet products. It is based on
mature and stable, cost-effective EPON/GPON technology, high reliability, easy management,
configuration flexibility and good quality of service (QoS) guarantees to meet the technical
performance of IEEE802.3ah and ITU-TG.984.x , China Telecom EPON/GPON equipment
technical requirements and other specifications.
Figure 1 1GE+1FE+WiFi ONU Figure 2 1GE+1FE+WiFi+CATV ONU
1.2 Product categories
Product model
Product specification
Chipset
SDRAM Memory
V2802W
1 G/EPON+1GE+1FE+WiFi
Realtek
64MB
V2802WT
1 G/EPON+1GE+1FE+WiFi +CATV
Table 1 Product categories
Dual mode
CATV ONU

G/EPON 1GE+1FE+WiFi+CATV ONU Introduction V1.1
2 Access the world
1.3 Application Chart
Figure 3 Application Chart
1.4 Technical parameters
Technical item
1GE+1FE+WiFi
1GE+1FE+WiFi+CATV
PON interface
1 G/EPON port(EPON PX20+ and GPON Class B+)
Receiving sensitivity: ≤-28dBm, Saturability: -8dBm
Transmitting optical power: 0~+4dBm
Transmission distance: 20KM
Wavelength
Tx1310nm,Rx 1490nm
Tx1310nm,Rx 1490nm and 1550nm
Optical interface
SC/UPC connector
SC/APC connector(signal fiber with
WDM)
LAN interface
1 x 10/100/1000Mbps and 1 x 10/100Mbps auto adaptive Ethernet
interfaces. Full/Half, RJ45 connector
WiFi interface
Compliant with IEEE802.11b/g/n
Operating frequency: 2.400-2.4835GHz
support MIMO, rate up to 300Mbps
2T2R,2 external antenna 5dBi
Support: multiple SSID
Channel:13
Modulation type: DSSS、CCK and OFDM
Encoding scheme: BPSK、QPSK、16QAM and 64QAM
CATV interface
RF, optical power : +2~-18dBm
Optical reflection loss: ≥45dB
Optical receiving wavelength: 1550±10nm
RF frequency range: 47~1000MHz, RF output impedance: 75Ω
RF output level: ≥ 82dBuV（-7dBm optical input）
AGC range: +2~-7dBm/-4~-13dBm/-5~-14dBm
MER: ≥32dB(-14dBm optical input), ＞35(-10dBm)
LED
6, For Status of POWER、LOS、
PON、GE、FE、WiFi
7, For Status of POWER、LOS、PON、
GE、FE、WiFi、CATV
EPON/GPON OLT

G/EPON 1GE+1FE+WiFi+CATV ONU Introduction V1.1
3 Access the world
Operating
condition
Temperature: 0℃～+50℃
Humidity: 10%～90%（non-condensing）
Storing
condition
Temperature: -30℃～+70℃
Humidity: 10%～90%（non-condensing）
Power supply
DC 12V/1A
Power supply
≤6W
≤7W
Dimension
185mm×120mm×34mm（L×W×H）
Net weight
0.24Kg
0.29Kg
Table 2 Technical parameters
1.5Panel lights
V2802W
V2802WT
LED
Mark
Status
Description
Power
PWR
On
Device is powered up.
Off
Device is powered down.
Optical signal
loss
LOS
Blink
Device does not receive optical signals.
Off
Device has received optical signal.
Registration
REG
On
Device is registered to the PON system.
Off
Device is not registered to the PON system.
Blink
Device is registering.
Interface
GE、FE
On
Port is connected properly.
Off
Port connection exception or not connected.
Blink
Port is sending or/and receiving data.
PWR LOS REG GE FE CATV WiFi

G/EPON 1GE+1FE+WiFi+CATV ONU Introduction V1.1
4 Access the world
Wireless
WiFi
On
WiFi turned on.
Off
Device is power off or WiFi turned off.
Blink
WiFi data transmission.
CATV(for
V2802WT)
CATV
On
1550nm wavelength power of input is in normal range.
Off
1550nm wavelength power of input is too low or no
input.
Blink
1550nm wavelength power of input is too high.
Table 3 Panel lights on
1.6 Interface description
Port Type
Function
PON
V2802W: SC/UPC type, single mode optical fiber cable
V2802WT: SC/APC type, single mode optical fiber cable with WDM
GE、FE
Connect device with ethernet port by RJ-45 cat5 cable.
RST
Press down reset button and keep1-5seconds to make the device
restart and recover from the factory default settings.
DC12V
Connect with power adapter.
CATV★
RF connector.
Power On/OFF
Power turn on/off.
Table 4 Interface description
Note:
1. With ★tags, it is only for V2802WT.
1.7 Software Parameters
Parameter
Name
Software Parameters
EPON/GPON
mode
Dual Mode , Can access EPON/GPON OLTs(HUAWEI、ZTE、FiberHome,
etc)
Software
mode
Bridging and Routing Mode
Basic
Support MPCP discover&register
Support authentication Mac/Loid/Mac+Loid
Support Triple Churning
Support DBA bandwidth
Support auto-detecting, auto-configuration, and auto firmware upgrade
Support authentication SN/Psw/Loid/Loid+Psw
Alarm
Support Dying Gasp
Support Port Loop Detect
Support Eth Port Los
LAN
Support Loop Detection
Support Storm Control

G/EPON 1GE+1FE+WiFi+CATV ONU Introduction V1.1
5 Access the world
VLAN
Support 4K VLAN
Support VLAN Tag/untag
Support VLAN Translation
Support VLAN Bound
Support Auto VLAN Detection
Multicast
Support IGMPv1/v2
Support IGMP Snooping
Support MLD
Max Multicast Group 64
QoS
Support 4 queues
Support SP and WRR
Support 802.1P
L3
Support DHCP/PPPOE/Static IP
Support NAT
Support DHCPv6 Server
Support IPv4/IPv6 Static route
Support IPv4/IPv6 dual stack
WiFi
IEEE802.11b/g/n (TX power:17dBm/16dBm/15dBm),Up to 300Mbps
Support Authentication : WEP/WAP-PSK(TKIP)/WAP2-PSK(AES)
Support multiple SSID and SSID conceal
Support Wireless channel selection
CATV
Support CATV management
Management
Support CTC OAM 2.1 and 3.0
Support ITUT984.x OMCI
Support WEB
Support Telnet
Support CLI
Support unified network management of VSOL OLT
Throughput
Upstream >900Mbps
Downstream >950Mbps
Packet lost
14Hours /Lost 0
Table 5 Software Parameters