Vacmaster CDM0610P User manual

10L 620W
CDM0610P
Original Instructions

18
9
2
3
4
13
5
17 18
21 22 23
19 20
15 1614
610
12
11
7

6
GB
TABLE OF CONTENTS
SECTION PAGE
Symbols..........................................................................................................................................
Safety Information ..........................................................................................................................
Unpacking and Checking Carton Contents.....................................................................................
Assembly........................................................................................................................................
Operation........................................................................................................................................
Maintenance...................................................................................................................................
Troubleshooting..............................................................................................................................
Technical Data................................................................................................................................
Recycling and Disposal..................................................................................................................
Plug/Fuse Replacement (UK & Ireland Only).................................................................................
6
7
9
9
10
11
12
13
13
14
Thank you for purchasing this Vacmaster® vacuum cleaner. Feel condent that with Vacmaster®
you are obtaining a high-quality product that is engineered for optimal performance. This vacuum
cleaner is suitable for use with dry materials.
FOR YOUR SAFETY: CAREFULLY READ AND UNDERSTAND ALL INSTRUCTIONS.
SYMBOLS
Caution
Read instruction manual.
Appliance in which protection against electric shock does not rely on
basic insulation only but in which additional safety precautions are
provided, such as double insulation or reinforced insulation, there
being no provision for protective earthing or reliance upon installation
conditions.

7
GB
SAFETY INFORMATION
READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE
USING THIS VACUUM CLEANER.
When using the equipment, a few safety precautions must be
observed to avoid injuries and damage. Please read the complete
operating manual with due care. Keep this manual in a safe
place so that the information is always available. If you give
the equipment to any other person, give them these operating
instructions as well. We cannot accept any liability for damage or
accidents which arise due to a failure to follow these instructions
and the safety information.
• This machine is for dry and indoor use only.
• Never leave the appliance switched on unattended, if you leave
the work area, switch the appliance off or unplug it from the
power supply.
• Do not vacuum or use this vacuum cleaner near ammable
liquids, gases or explosive vapours like gasoline or other fuels,
lighter uids, cleaners, oil-based paints, natural gas, hydrogen,
or explosive dusts like coal dust, magnesium dust, grain dust
or gun power, or toxic materials. Sparks inside the motor
can ignite ammable vapours or dust. Do not vacuum toxic
materials.
• This vacuum cleaner is not suitable for the vacuuming of
asbestos or asbestos dust.
• Do not vacuum anything that is burning or smoking, such as
cigarettes, matches, or hot ashes.
• Do not use the vacuum cleaner in a wet environment or to
vacuum wet materials.
• Do not use steam cleaners, pressure washers or immerse in
water to clean the vacuum cleaner.
• Ensure the hose and connections are always pointed away
from the users face, hair, ears and eyes during operation and
never direct the nozzle towards persons or animals.
• Clear the working area of any items or possessions that you do
not wish to be vacuumed before operation.

8
GB
• Keep cord away from heated surfaces.
• Do not expose to rain. Store indoors.
• Do not unplug by pulling on the cord. To unplug, grasp the plug,
not the cord.
• Do not use with damaged cord, plug or other parts.
• Do not pull or carry by cord, use cord as handle, close a door
on cord, or pull cord around sharp edges or corners.
• Do not handle the plug or vacuum cleaner with wet hands.
• Do not use or store near hazardous materials.
• Do not use this vacuum cleaner with a torn lter or without the
lter installed.
• Do not allow to be used as a toy. Close attention is necessary
when used by or near children.
• Do not leave vacuum cleaner unattended when plugged in.
Unplug from power supply when not in use and before carrying
out maintenance.
• Turn off vacuum cleaner before unplugging.
• Do not cover the ventilation openings. Do not vacuum with any
ventilation openings blocked; keep free of dust, lint, hair or
anything that may reduce air ow.
• Keep hair, loose clothing, ngers, all parts of body away from
openings and moving parts.
• If the supply cord is damaged, it must be replaced by the
manufacturer, a qualied service agent or similarly qualied
persons in order to avoid a hazard.
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that they do not play
with the appliance.
• For additional protection: It is recommended that this vacuum
cleaner can be used in conjunction with residual current device
(RCD) with a rated residual current of 30mA or less.
• Always unplug the appliance after use and before cleaning or
changing the lters or accessories.

9
GB
UNPACKING AND CHECKING CARTON
CONTENTS
ASSEMBLY
NOTE: A Phillips screwdriver is required.
1. Remove all the contents from inside of the vacuum cleaner container.
2. Your vacuum cleaner comes ready for dry vacuum cleaning with the pre-lter pre-installed. If
the pre-lter is not installed, refer to page 10.
3. Optionally, for improved dust ltration, remove the pre-installed pre-lter, and then fully t the
dust bag ange onto the inlet stub (Fig. 1). Place the pre-lter back into the container. The
vacuum cleaner can be used with or without dust bags.
4. Secure the power head back on the container, using the 2 push-to-lock side latches. Insert the
locking end of the hose into the suction port of the container and turn clockwise to lock into
place (Fig. 2).
5. Choose the desired accessories and/or extension wands and push t onto the hose nozzle
(Fig. 3).
6. Attach the detachable power cable to the connection lead using the cable restraint hook (Fig. 4).
1Power Head 9 Accessory Storage 17 Round Dust Brush
2 Latch 10 Exhaust Filter Door 18 Pre-lter (pre-installed)
3 Rear Wheel 11 Hose Storage 19 Extension Wand (x2)
4 Front Caster 12 Power Cable Hook 20 Exhaust Filter (pre-installed)
5 Suction Port 13 Suction Hose 21 Detachable Power Cable
6 Container 14 Dual Mode Floor Nozzle 22 Cable Restraint Hook
7On/Off Switch 15 Dust Bag (x5) 23 Instruction Manual
8Carry Handle 16 Crevice Tool

10
GB
1. Switching On/Off
Connect the mains plug to a suitable power outlet.
To turn the vacuum cleaner ON, press the power switch once.
To turn the vacuum cleaner OFF, press the power switch again.
2. Dry Vacuum Operation
OPERATION
1) This vacuum cleaner can be used with or without dust bags. To use a dust bag, remove the
pre-installed pre-lter and fully t the dust bag ange onto the inlet stub.
2) Place the pre-lter back into the container. Ensure the notch of the pre-lter is aligned with the
inlet stub. The pre-lter is designed to cover the full circumference of the container (Fig. 5).
3) Secure the locking end of the hose into the vacuum suction port.
4) Push the desired accessories onto the hose nozzle. The air ow regulation on the suction hose
allows you to change vacuum cleaner suction. For best cleaning results, fully close the air ow
regulation (Fig. 6).
5) Verify that the container latches are secured. Plug the power cord into a power outlet.
6) Turn on the motor by pressing the On/Off switch.
7) Once you have completed vacuuming, press the On/Off switch again and unplug the power
cord from the power.
WARNING: ENSURE YOU READ, UNDERSTAND AND APPLY SECTION ENTITLED
‘SAFETY INFORMATION’.
WARNING: BEFORE INSTALLING, REMOVING OR CLEANING THE VACUUM
CLEANER FILTER, ENSURE THAT THE POWER CORD IS UNPLUGGED AND
SWITCHED OFF.
IMPORTANT: Check the lter regularly for optimal performance. An old or blocked lter will
reduce suction performance.

11
GB
MAINTENANCE
WARNING: REMOVE THE POWER CORD FROM THE POWER SUPPLY BEFORE
CARRYING OUT ANY MAINTENANCE.
1) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry
brush to clean the equipment regularly.
2) Clear all dirt or debris from the container after each use. Allow to dry before replacing the power
head. Do not use cleaning agents or solvents; these may damage the appliance.
3) Check the hose, attachments, and power cord to verify that they have not been damaged or
any debris is trapped and blocking airow.
1. Cleaning the Pre-lter
1) Remove the pre-lter and clean by gently tapping or brushing dirt off. For optimal performance
it is recommended to replace the old lter with a new lter regularly.
2) If necessary, use a mild soap and water solution to wash pre-lter and rinse with clean water.
Allow the lters to air dry before re-installing.
2. Cleaning the Air Inlet Filer
1) Remove the air inlet lter by releasing the holding pin. Firmly press the two open ends of the
holding pin together and remove from the securing tabs (Fig. 7)
2) Remove the air inlet lter and use a mild soap and water solution to wash air inlet lter and
rinse with clean water. Allow the lter to air dry before re-installing.
3. Cleaning & Replacing Exhaust Filter
1) Unlock the exhaust lter door by lifting both of locking tabs upwards to release. Pull the door
out (Fig. 8).
2) Remove the exhaust lter from the vacuum cleaner and clean by gently tapping or brushing off
dirt. For optimal performance it is recommended to replace the old lter with a new lter
regularly (Fig. 9).
3) Install the cleaned or new lter. Then insert the lter door tabs into the upper slots and lock the
lter door into place.
4. Storage
1) Ensure the power cable hook is fully rotated into the storage position. Wrap the power cable
loosely around the power cable hook (Fig. 10).
2) To release the power cable, rotate the power cable hook towards the front of the vacuum
cleaner.
3) Store the suction hose around the hose storage (Fig. 11).

12
GB
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK-UNPLUG BEFORE
TROUBLESHOOTING.
Cleaning Performance
Vacmaster vacuum cleaners are tested for endurance. If your motor is operating, then the most
likely cause for a loss in suction is a blockage or an opening in the vacuum.
To maintain a high cleaning performance from your machine, it is important to replace or clean
pre-lters as necessary. Replace full dust bags to prevent performance drops. A performance drop
with clean lters can only be caused by a blockage in the tools or the hose.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
The appliance does not work.
No power. Check the power supply and
fuse.
Functional fault in the power
cord, switch, or motor.
Have the damaged part
checked by qualied personnel
or contact the after sales
helpline.
Dust is escaping from the motor
cover.
The pre-lter is missing or
damaged.
Ensure the pre-lter is correctly
installed or replace if damaged.
The air inlet lter is missing or
damaged.
Ensure the air inlet lter is
correctly installed or replace if
damaged.
Low suction power and high
operating noise / vibrations.
Dust bag is full. Replace the dust bag.
Suction nozzle, hose, or tank
inlet is blocked.
Check the suction nozzle, hose,
and tank inlet for obstructions.
The pre-lter or air inlet lter
needs to be cleaned.
Check and clean the pre-lter
and air inlet lter. Replace if
damaged.

13
GB
RECYCLING AND DISPOSAL
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. The machine must be delivered in rigid packaging to avoid damage during
transportation. The packaging and the machine itself are manufactured from recyclable
materials and should be disposed of accordingly.
TECHNICAL DATA
Model Number CDM0610P
Motor 220-240V~50Hz
Power Input 620W
Tank Volume 10L
Net Weight 11kg
Energy Efciency Class A
Annual Energy Consumption in kW▪h per Annum 24.8 kW▪h /annum
Cleaning Performance on Carpet B
Cleaning Performance on Hard Floor A
Dust Re-mission A
Noise/Vibration Information
Noise emission values determined according to EN 60335-2-69.
Typically, the A-weighted sound pressure level of the power tool is 58 dB (A). Uncertainty K = 3 dB
Total vibration values ah(triax vector sum) and uncertainty K determined according to EN 60335-2-
69: ah<2.5 m/s2, K =1.5 m/s2.

14
GB
PLUG/FUSE REPLACEMENT (UK &
IRELAND ONLY)
This product is tted with a non-rewirable plug. If the plug has to be changed, refer to the picture
below.
6mm
6mm
FUSE
FITTED WITH BS 1362 13A FUSE ALWAYS RT FIT BS 1362 REPLACEMENT CARTRIDGE FUSE
6mm
32mm
E
L
N
13A
GREEN&
YELLOW
OR
GREEN
BROWN
OR
RED
CORD GRIP
BLUE
OR
BLACK

1 2 3 4
6 7
89 10 11
5

19
GB

CDM0610P
Suzhou Cleva Electric Appliance Co., Ltd.
No.8 Ting Rong Street
Suzhou Industrial Park, Suzhou
Jiangsu Province, China
www.cleva-europe.com
Made in P.R.C