10
GB
MAINTENANCE
CAUTION: To reduce the risk of electric shock, turn the vacuum cleaner off and
remove the charging adapter from the vacuum cleaner before any maintenance.
WARNING! Donotoperatethevacuumcleanerwithoutltersinplace.
1. Emptying the Dust Bin
NOTE:Forbestperformance,emptydustbinaftereveryuseoroncedustreachesMAXllline.
Before emptying the dust bin, ensure the vacuum cleaner is turned off.
1) Position dust bin area of vacuum over a waste receptacle. Press down on the dust bin door
release button to open dust bin lid and allow bin contents to drop into waste receptacle (Fig. 17).
2) Close the dust bin door until you hear a click.
2. Cleaning the Filters
NOTE:Thekeytomaximumperformanceishavingacleanlter.Cleaningthelterfrequentlywill
helpyourvacuumcleaneroperateatpeakefciency.Asparelterisprovidedwithyourvacuum
cleanertoallowyoutodryonelterproperlywhileusingtheother.Additionallterscanbe
purchased from www.cleva-europe.com.
1) With one hand grasped around the handle, press the motor head release button to separate
the dust bin from the handheld vacuum (Fig. 18).
NOTE: Grasp the dust bin when pressing the release button.
2) Removethelterandltercagefromthedustbin(Fig.19).
3) Useasoftbrushtocleanloosedebrisfromthelterandthenrinsewithwarmwater.Rinseand
gentlysqueezedrythelters.Setallltersasideandallowtoairdryfor24hours.
IMPORTANT:Theltersandtheltercagemustbecompletelydrybeforereuse.
4) Placetheltercagebackintothedustbin,thenplacethelterbackin.
5) To reassemble the dust bin to the handheld vacuum, align the tabs on the dust bin with slots in
the handheld vacuum. Once aligned, attach the dust bin to the handheld vacuum until you hear
a click (Fig. 20).
3. Cleaning the Motorised Floor Head & Blockage
Remove the Brush Roll
1) Make sure the vacuum cleaner is turned OFF, then remove the wand and set aside.
2) Turntheoorheadovertoaccessthebrushroll.Pressandpushthetabonthelefthandside
of the head to the left and hold it. This will unlock the brush roll (Fig. 21).
3) With the tab pushed to the left, simply lift the brush roll out of the head housing. Clean off
debris
and anything wrapped around the brush roll. Use a pair of scissors to remove threads, etc.
4) Place the brush roll back into the housing by aligning the hexagonal end of the brush roll into
the right end of the head. Then push the unlock tab to the left and hold it. Align the square end
of the brush roll with the left end of the head and insert it into place (Fig. 22). Release the tab to
lock the brush roll.
