Valley-Dynamo Valley User manual

Assembly instructions for
Valley Home Pool Tables
CAUTION
We strongly recommend this assembly/installation is performed by professionals.
This table is very heavy –No less than 2 People are required to install this table.
NEVER ALLOW THE BOX TO STAND ON ITS OWN ASSEMBLE NEAR THE TABLE’S FINAL LOCATION
1. Stand box on one of the long sides and remove the banding.
(Box shown without support or A-frame for illustration only)
NEVER ALLOW THE BOX TO STAND ON ITS OWN

2. Very carefully lean the table box back slightly and pull the top of the box off.
3. Remove Box Top, End Protectors, and Slate Protective Pad.
4. Place a protective piece of carpet or cardboard in front of the table on the floor.

5. With one person supporting the table, another should grasp the table by the
Bottom Corner Pockets and pull it straight out.
6. Lean table slightly forward and remove the Box Bottom, making certain the bottom
Packing Wedge remains in place.

7. Remove the key from the Access door, open the door and remove the
Hardware Pack and (4) Legs inside.
REMOVE PHILLIPS
SCREW TO REMOVE KEY
REMOVE
THUMBSCREW TO
REMOVE LEGS

8. Attach each leg to the bottom of the table using 4 bolts.
Attach the bottom two legs first.
9. Screw the Leg Levelers all the way in and replace the Bottom Access Door.

10. Have at least 2 People carefully tilt the table down onto its legs.
11. To level the table place the level in various locations on the slate and
rotate the Leg Levelers as needed using a large adjustable wrench or tongue and
groove pliers such as Channellock® . Helpful tip, it is MUCH easier to raise and
lower the leveler when another person is lifting up that corner of the table during
adjustment
Larger levels will produce better results. Level your table using the longest
level you can find.