Vari Lite NEO X15 User manual

1
NEO X15
QUICK START GUIDE
Part Number: 443581628025 REV A 10/13/22
OVERVIEW
Neo X15 54101-004 Lighting Console
This document provides basic setup instructions
and safety warnings for the following product(s):
CONNECTING POWER
This console requires standard AC power distribution from 100-240VAC. Current
required depends on the AC supply voltage and product model.
NOTE: The mating compatible connector is supplied; however, you will need to
purchase or construct a cable appropriate for your application.
Depending on the application, the Console’s AC input cable may require a dierent
connector. If required, install a new connector meeting your requirements using
the following wire color code reference:
WARNING: DO NOT connect to three-phase service in countries with 240V power.
INSTALLATION AND SETUP
WIRE* CONNECTION
Green/yellow AC ground
Blue AC neutral
Brown AC line
* International (Harmonized) Standard
Single-phase power from 100-240V RMS: Two-phase power at 208V RMS:
CONNECTION PIN
AC neutral X
AC line Y
Ground (earth) G
X
Y
G
CONNECTION PIN
Phase 1 X
Phase 2 Y
Ground (earth) G
INCLUDED ITEMS

2
NEO X15
QUICK START GUIDE
Part Number: 443581628025 REV A 10/13/22
CONNECTIONS
Figure 1 shows the features and controls of the NEO X15 Lighting Control Console. Refer to the on-line
manual for additional information and operation.
Figure 1: Neo X15 Lighting Control Connections
Use only the supplied AC input cables with unit. If the supplied AC input cable is ever damaged, you
must replace it with an approved replacement. For assistance, please contact an Authorized Vari-Lite
Lighting Dealer or Service Center. Authorized Dealers and Service Centers are found on the Vari-Lite
web site at www.vari-lite.com.
Console Light Receptacle (x2) VESA Display Port (x2)
SMPTE In/Out
AC Input USB A (x2)
DMX Output (x4)
DMX Input
Audio In Audio Out (L&R)
Midi In/Out/Thru
Rear of Unit
Network Ports (x2)
USB C (x2)

3
NEO X15
QUICK START GUIDE
Part Number: 443581628025 REV A 10/13/22
GETTING STARTED
1. UNPACK CONSOLE
Unpack your Neo X15 Lighting Control Console from its shipping box and insure you have all included
items. A list of included items is found in “Included Items” on page 1 of this guide. If you are missing
any components, please contact your local Authorized Vari-Lite Dealer. Authorized Dealers are found
on the VariLite web site at www.vari-lite.com.
2. SITE REQUIREMENT
The Neo X15 Lighting Control Console requires a sturdy, flat surface for installation. The surface should
be able to support the weight of the console and should provide suitable ventilation. Also, the site
should be clean (i.e. absent of any construction dust or debris) and dry. Before setting up, ensure that
the installation site meets these requirements. For operational and space requirements, refer to “Neo
X15 Lighting Control Console Connections” on page 2 and “Console Dimensions” on page 4 for more
information.
The console must be installed and operate in an environment that is not exposed to moisture, high
humidity or direct sunlight.
3. CONNECTING POWER
If applicable, connect monitor(s) before connecting power.
To connect the power supply:
Step 1. Make sure unit’s power switch is set to “O”
Step 2. Connect AC input cable to AC Input connection on console (refer to Figure 1 on page 2).
Step 3. Connect AC input cable to AC supply source.
Step 4. Turn on console at Console On / O Switch.
Note: You must connect the console to the lighting system before it is capable of providing control.
Refer to “Connections” on page 2 for connection information.
4. READY TO USE
Once console is connected to power and lighting control system, it is ready for use.
• Power on the console.
• Once the software boots, you are ready to program.
• Channels can be adjusted by selecting the channels and applying a value. [1 THRU 10 FULL].
• A Cue can be recorded for timed playback. [RECORD CUE 1 ENTER] or a Submaster can be recorded
for fader playback. [RECORD SUB 1 ENTER].
For more information, refer to the on-line manual for console operation, operational features, and
programming.

4
NEO X15
QUICK START GUIDE
Part Number: 443581628025 REV A 10/13/22
CONSOLE LAYOUT
Figure 2: Neo X15 Dimensioned drawings

5
NEO X15
QUICK START GUIDE
Part Number: 443581628025 REV A 10/13/22
WARNING: It is the responsibility of the user to adequately protect supply source with a correct size and type circuit
breaker and not overload circuits.
WARNING: This unit has a battery. Replace only with the correct type of battery. Failure to use the correct battery
could cause serious damage to the fixture. Dispose of used batteries appropriately.

6
NEO X15
QUICK START GUIDE
Part Number: 443581628025 REV A 10/13/22
SAFETY WARNINGS AND NOTICES
Read this user manual in full before attempting to install, operate or maintain the Console to which it relates. This user manual is intended
to provide general guidance to such suitably qualified personnel. Installation and operation of the Console are to be performed by qualified
personnel only.
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
SAVE THESE INSTRUCTIONS.
WARNING: Refer to National Electrical Code® and local codes for cable specifications. Failure to use proper cable can result in damage to
equipment or danger to personnel.
COMPLIANCE NOTICE
FCC DECLARATION OF CONFORMITY
This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of FCC Rules. These limits
are designed to provide reasonable protection against harmful interference when this equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with Vari-Lite system, service,
and safety guidelines, may cause harmful interference to radio communications.
As tested under this standard:
FCC 47CFR Part 15 Subpart B
ICES-003
Operation of this equipment in a residential area is likely to cause harmful interference, in which case the user will be required to correct the
interference at his/her own expense.
EU DECLARATION OF CONFORMITY
We, Vari-Lite LLC., 10911 Petal Street, Dallas, Texas 75238, declare under our responsibility for the products contained herein are in conformity
with the essential requirements of the following European Directives and harmonized standards:
Low Voltage Director (LVD), 2014/35/EU
EN 62368-1
Electromagnetic Compatibility Directive (EMC), 2014/30/EU
EN 55032, EN 55035
• Equipment should be mounted in locations and at heights where
it will not be readily subjected to tampering by unauthorized
personnel.
• Not for residential use. Do not use this equipment for other than
intended use.
• This equipment is not suitable for use in locations where children
are likely to be present.
• Note distance requirement(s) from combustible materials or
illuminated objects. Do not mount near gas or electric heaters.
• Install only in locations with adequate ventilation. Ensure sure that
ventilation slots are not blocked.
• Ensure that the voltage and frequency of the power supply match
the power requirements of the Console.
• The Console must be earthed/grounded to the appropriate
conductor.
• Do not operate Console outside the specified ambient temperature
range.
• The use of accessory equipment not recommended by the
manufacturer may cause an unsafe condition and void warranty.
• Refer service to qualified personnel. This Console contains no user
serviceable parts.
• Prior to first use, carefully inspect Console to ensure no damage has
occurred during shipping.
• Materials used in the manufacturing process can cause strong odors
when the product is new. These odors dissipate over time.
• Prior to each use, carefully inspect power cables and replace any
damaged cables.
• Continuous use of the Console may shorten the lifespan. Power
down the Console when not in use.
• Do not cycle power on and o repeatedly. Disconnect mains power
if the Console is not used for an extended period.
• Clean Consoles regularly, particularly when working in a dusty
environment.
• Never touch power cables or wires while the Console is powered on.
• Avoid entangling power wires with other cables.
• In the event of a serious operating problem, immediately
discontinue using the Console.
• This is a Class A product. In a domestic environment this product
may cause radio interference, in which case, the user may be
required to take adequate measures.
©2022 Signify Holding. All rights reserved.
All trademarks are owned by Signify Holding or their respective owners.
The information provided herein is subject to change, without notice.
Signify does not give any representation or warranty as to the accuracy
or completeness of the information included herein and shall not be li-
able for any action in reliance thereon. The information presented in this
document is not intended as any commercial oer and does not form
part of any quotation or contract, unless otherwise agreed by Signify.
Data subject to change.
CUSTOMER SERVICE
If you have any questions regarding this product, please con-
tact Customer Service by phone at [phone] or by email
at [e-mail].
6
NEO X15 QUICK START GUIDE
PART NUMBER: 443581628025
VERSION: REV A OCTOBER 13 2022